开云体育

Robert, I have uploaded an updated file to your folder: /g/jmriusers/files/ProblemsBeingWorkedOn/cvc-identity-constraint.4.2.2%20Error/Roberts%20Layout40%20DS.xml There were 133

NCE USB Setup Windows ================== - The NCE USB uses the SiLabs CP2102 chipset. Download and install SiLabs CP210x drivers from

*if you can upload the output from the jmri consol it will probably contain clues as to why you are having issues. John*

Could it be that those Bachman’s decoders don’t do read back? Or alternatively their responses are so weak that they require the use of a program track booster to alert the command station to

Bob, I am using Acrobat Pro DC on the Scanned images of the printed output. However, it is the inability to save the output to anywhere so that I can convert the out.prn file that is the problem. As

File "Roberts Layout40.xml" has been uploaded to subfolder "cvc-identity-constraint.4.2.2 Error" in the "Problems Being Worked On" folder

I have built a panel in CPE and it works correctly. However, it looks clunky because I lined up all the icons by eye. I know I can edit the x/y coordinates for each individual icon but that will be a

Pino, I don't have an IB to try any of this; however, as Bob noted, some of the BDL168 connection is working right.? Here are a couple of things to try: 1.? Check Op Switch settings 11 and 12.? You

I forgot to mention that there were some serious speed issues with reading ESU CVs on the DCS240 when it first came out. My memory is that it was finally resolved and may have involved a DCS firmware

I don't know who told you that, but it's very untrue. Most DCC systems are fine with ESU decoders. See my other posting. Your solution is a sure recipe for disaster with ESU decoders! -- Dave in

If you are reading a LokSound V4 or Select decoder in Paged Mode, it will take 25-30 minutes. It should be about half that in Direct Mode. These decoders have around 1,000 CVs and there are physical

I have discovered that hitting read all sheets is basically fatal on ESU , all you can do is hit the write? the page and leave it at that .this was the solution given last time ESU was discussed?

The detect is dependent on the manufacturer identification and as you found not all use different values so JMRI only can do so much with limited data. David Klemm Sent from my iPhone Xs Max

Thanks Bob for providing the boundary conditions. That's critical information, better than I feared. I'd like to thank whoever wrote the MQTT code already in JMRI.? That's a big first step and opened

Thanks for replay David.? This is a brand new install, all the latest.? JMRI 4.12, DCS240 latest firmware.?? I also wish that I wouldn't be given 20 different options of decoders when I do

Tooooons, What version of JMRI are you on? My guess it is to old to have the DCS240. My club uses a 240 and it is in the selection. And Loksound taking a long time is normal in my opinion given its

Good afternoon. I would appreciate a little guidance. I have a win10 computer that had previously functioned with my layout fine (March). I rebuilt the machine a few months ago and today reloaded JMRI

I have the latest JMRI installed on a Windows 10 64bit system, brand new USB cable, new Digitrax DCS240, and less than two feet of wire to the programming track. It takes like 25-30 minutes to "read

Hi Bob, The JMRI on-screen throttles won't move then after a short time they free up.? Very difficult when you are trying to control a train.? Graham

I asked about this some months ago but got no replies so I'm trying again. I'm using DCC++ running on an Arduino, with Panel Pro 4.11.7 on my Mac. ?I have tried every possible combination of Arduino