开云体育

Hi, The dispatcher tells Extra CR2340 is clear from Echo 3 to Jackson 1 via radio. In JMRI the train name is put into the Tools>Blocks>Value for Echo3 (iconified window).? Echo 3 would show occupied

Gabor, On the main menu will be an entry for each connection. The first sub-menu item is normally used to open a monitor dialog. The monitor displays all of the messages passing between JMRI and the

Thanks Steve, I can update the config now I know - I thought that was probably the case. I use a bluetooth keyboard.

Hi Andrew, the steps I took to enable the serial interface for the PiSPROG do disable the bluetooth. You can undo them (referring to the prior post), or I can post the link to the 8/13 image, which

Andrew, I can only speculate since I don’t have this hardware arrangement available to me. Here are the steps that I would use after adding "Open JMRI System console" to "Preferences >> Start Up"

Paul, I tested build 2642. Is better than the previous, but there is still a problem in the single CV programmer: if I write a CV value greater than 128, after the POM CV write, textbox value decrease

Could someone add the mentioned loco to the list of choices of locos highlighted when reading the decoder. May have been inadvertently left off ??? just would make helping someone over the phone a

Hi Steve I installed the image and have it up and running but I have no bluetooth - adapter not found. It is Pi3 B with built in bluetooth. Does the pi3-miniuart-bt overlay affect this? Is it intended

Jay, that is most interesting. I have had a look over the general instructions, which give me an idea of what you have achieved but not so much how you have achieved it, and it would be most useful to

Your offer of further help has come at the psychologically right moment when I was feeling discouraged after an attempt, at Ken's suggestion, of applying ReporterFormatter.py in BackAndForth.py.

Hello, This email message is a notification to let you know that a file has been uploaded to the Files area of the [email protected] group. *File:* JMRI TCS Non-WOW Decoder Improvements.zip

The turnout error can change the referenced turnout but is something like this (my DCC++ turnouts are DT67 through DT98 and I have seen messages on DT67, DT68, DT71 randomly): "Unexpected error

The sensor error I sometimes get is: "Could not create sensor System name "ISCLOCKRUNNING" in adaptor of type jmri.jmrix.internal.configurexml/ErrorHandler.shtml"

All, I am running Raspberry Pi with Raspbian Stretch 9 Java 1.8.0_65 Panel Pro 4.12+Rb6a9bb1 DCC++ though Arduino Mega 2650 with Pololu motor shield I have setup my command stations properly and with

Moreno, Please try build 2642 or later. The first issue above was caused by not interpreting the LocoNet response correctly. Strangely, this only impacted the single CV programmer and I had been

Folks I want to thank you all for your help. Issue solved. By using the system console it became apparent to me that all the issues had to do with one of the AIU's. When I looked at the sensor table

Sounds feasible and sensible.? Do backups, and name them so you can easily recover in case you don't like the results. Dan

Hi Gary, I think that will work.?? I would do a backup before replacing the car file in case it doesn't work.? Let us know if you run into any issues. Dan

Found it. Thanks! Allen

I have downloaded the new image and loaded it on my Pi-Sprog One and it works flawlessly!!! Thanks, Steve for your excellent support and persistent work on this issue. Bob Johnson Allen, TX Sent: