开云体育

Dear Tony, I too have encountered issues with the Broadway Limited units. One Paragon2 PA1 in particular will not reset from it's 03 default. I have come across mention of "Blast Programming" (see

Might be chasing ghosts. I loaded Engine Driver 2.20.59 onto my smart phone and tablet. Both performed without incident at the club today. At this point, I suspect either a bad install on the member's

I am in the process of trying to test JMRI's automation capabilities using a small testing layout in (UK) N gauge especially built for this test. The layout consists of a straight topped and bottomed

Tony, The help section is a good place to start. On the "Trains" page and edit train, one can designate the Railroad and Engine Type for that train.

Tony That will be all part of your JMRI Operations set-up. You can have a particular type of engine assigned to a particular train. But, you do NOT have to have JMRI assign an engine. My suggestion is

Jeff, Do the Route system names start with numeric characters? If so, you will need to carefully edit the panel xml file and add the IR prefix to each system name entry. Dave Sand

i am attempting to fix an issue with a friends jrmi withrottle setup. Running on a MacBook Pro High Sierra v10.13.6. ?? if I run jrmi 4.10 I can see routes and am able to set them via the laptop ,

thank you that solves the car problem but how does the program assign the correct engine such as sp daylite engine to the sp daylite set of cars tony

I suggest you start by reading the 'Help' files that are included with in JMRI download and are on the the JMRI website. http://jmri.org/help/en/package/jmri/jmrit/operations/Operations.shtml#Cars --

Steve: If you need additional testers for your Beta program I offer my time to do so. Bob M

https://postimg.cc/image/9j3qaetmj/

Brilliant! After upgrading to 4.12 I don't get error messages and Ican delete unneeded turnouts and signal heads.? Thanks for that. I'm still having turntable issues. Essentially, I can't get the

are passenger cars included in the cars database and engines used only to run passenger trains included in the engines database. is each individual car included as a separate item or the set listed as

The computer running JMRI my have both a wired and a wireless connection to your router. WiThrottle advertises on all available active connections. -- Dave in Australia The New England Convention 2018

Thomas It sounds as though the earth connection has come off the command station and static is jumbling the memory. Do a full reset on the command station - with power off, hold down the enter key,

Thomas, If you are on Windows, open a command window and use the command: Ipconfig That will list each possible connection interface and what, if any, address is associated with each. If that is

As far as I remember, the limit is 255, but when it gets that high, you should clear them out.

Our club PC with JMRI is connected to an EasyDCC system. Been working fine for years. However, or last several operating sessions, the system has gone nuts. Loks moving and reversing without operator

Our JMRI server automatically loads WIThrottle when it boots. After a kerfuffle last week, it is showing and broadcasting 2 IP addresses, and not showing the port number. 168.2.1.2 and 168.2.1.8 are

Not a problem! Happy to be able to get you a fix quickly. (I was a little worried about that, as 4.13.1 was already well along in the pipeline, so the next chance to publish a fix would be a while in