开云体育

ps: if i use the autotrain window to switch to manual and use the speed lever to move the train it doesnt respond either what am i doing wrong tony

i have my layout connected to computer running jmri 4.12. a layout panel using sml signals. sections are defined.transits are defined. dispatcher settings are set to run train automatically. enter a

Thanks for those. I should have asked you to turn on Timestamps and Show Raw Data in NCE Monitor so I could correlate with System Console (and get more information). Some observations: You launched

I've set up JMRI using the Layout editor (not Panel/Control Panel editor).? Can I use Warrants to automate my layout?? The JMRI website only gives examples of setting Warrants from the Control

1. JMRI system console output (including output from yesterday when trying to figure the problem out): 2018-07-13 18:48:12,603 util.Log4JUtil? ? ? ? ? ? ? ? ? ? ? ? INFO? - * JMRI

Three things I need to know: 1. The JMRI system console output (Help menu). 2. The NCE Command Monitor output (on the NCE menu and open it before you begin to read). 3. The behaviour of the USB LED

But I don't think this applies to El Capitan. -- Dave in Australia The New England Convention 2018 http://www.newenglandmodelrailwayclub.com/content/convention.shtml

Cut and paste beats retyping and getting,punctuation wrong. It's dev(vertical bar)head While : ;do clear;ls -lt /dev|head;i=$((i+1));echo $i;sleep 1;done -- Dave in Australia The New England

Hi Paul There is good news, there is nothing wrong with the panel that causes this and I have isolated the problem. There is a property in the Signal System that AutoTrains does not process correctly

I've just got around to a bit more investigation on this, mainly to see if I could identify why it seems difficult to recreate the problem or identify some other environmental issue. ?I've produced a

so i should ignore the program assigned directions and re-define them based on the train travelling in a loop. the layout is 2 connected loops and all sections except 2 are single blocks. tony

steve i am not asking which way to define things but why the program itself which defines direction when you enter the section info contradicts itself on parallel identical sections. should i use the

Tony Depends on what value you put on your sanity.. If you value it then: If its circular pick cw as one direction and ccw as the other. If its point to point make it A to Z in one direction and Z to

Tony, As you are talking about Sections, I assume you mean defiining them in the Sections table (and than use them in the Layout Editor panel with Dispatcher etc). First, can you confirm you have read

For some reason this download seems to be taking a long time to extract.? It seems to be the .png files, everything else it zooms through.? Thoughts? -- Jon Miller For me time stopped in 1941

And will consider making a donation to cover the miscellaneous expenses: http://jmri.org/donations.shtml Ross Sent: Saturday, July 14, 2018 10:55 AM To: [email protected] Subject: Re: [jmriusers]

Having purchased both RailOp and Protrak many years ago and watching JMRI develop I am extremely grateful to all who helped develop and enhance JMRI making it the best program out there for my needs.

/On 7/14/2018 7:32 AM, Bob Jacobsen wrote:// / Thanks Bob, you and the crew are doing a wonderful job.? I hope all users of JMRI realize all the effort that goes into this "free" software. -- Jon

Charles, ?Yes you can.? The instructions on how to do so are in the Operations "Help" and can also be found