开云体育

Re the NX issue, I think I have just worked it out. I have found the options that set how the route will behave if you re-select it. So I think I'm OK with it. Just curious as to why the right click

Thanks for that Dave, I have loaded your panel and low and behold all the logix is there and working. Once again thanks. On a side note I have NX routes for a part of my panel. These routes set when I

Hello Dave, Thanks for the reply and your help. I did have a look at the link you gave me, but unfortunately using the 640 interface unit is needed for the 511 or earlier, but the unit is not needed

John, Where do I find these sound files so that I may select the correct file? Regards,Dick

You can identify it for sure by removing the shrinkwrap and checking the number that will be written on the processor chip. That should be the last two digits of the serial number. There's no

Ken, According to my documentation, the 0x9B yy (short form AIU status) command is supported by by the V7.x.x/V1.65B combination. The 0x8A yy (long form AIU status) command is not. Although I

Darren, I have uploaded an updated panel xml to the same folder as "Cann River 7.4 DS.xml". All of the Logix and Conditional system names have IX added to the front. IX is the standard prefix for

Darren, I will take a look at it. Dave Sand

Hi Ken, my xml file Cann River 7.4 is in the folder 'Programs being worked on' sub folder 'Darren French' If one of the guru's could check out the issue that would be great. Thanks, Darren

Darren, The issue was old systems didn't force the system name for Logix to conform to a pattern. We now do require it. I suspect it will be a minor fix to your panel file. The simplest way is if we

I had a similar issue with a BLI NW2 with built-in QSI decoder. JMRI listed 3 possible decoders used in that engine, with different firmware revisions. I had no way of telling so chose the latest

Hi all, I have been following the can't access tables thread and seem to have a similar issue with logix. I am running JMRI 4.11.3 and when I open up my panel file, then select tools I can see the

Hi, I just installed a Digitrax DH126PS decoder and used DecoderPro to program it. All went great except for setting up the BEMF (what Digitrax calls Speed Stabilization). Now the Digitrax web site

Harold, AIU readback isn't supported in the PowerCab/SB3/SB5/Twin series of systems. There wasn't enough room in the memory for it to hold that information. Only the PowerPro command station (CS02)

Ted, Having CMRI won't interfere with the tables. You should be able to start JMRI, not loading any panels, and open the tables. Have you followed the directions to conclude if you do or don't have

To all, first, thank you for all the responses. Tonight, during our monthly session, after I sent the email and while running a bunch of stuff, I got a java error which deteriorated the virtual

Leo, Sounds like your process is similar to mine. The Quaker Valley RR has a Dlink wifi router in the train room which is not connected to the internet. I pull the plug on the connection to the house

You can't with Soundtraxx decoders prior to the Tsunami 2 and Econami.? In the earlier decoders, there is not any CV to uniquely identify which exact model and sound set it is. Soundtraxx ID info:

Please post your build report in very detailed mode and we'll figure out why your passenger cars aren't being picked up. Dan

Ted, If what you want are some examples for sending and receiving text through the USB connection between an Arduino and your JMRI computer, a good starting place is in the downloaded folder with the