开云体育

Ken Cameron, I have a new Windows 10 desktop and I installed JMRI 4.8. I have successfully setup the Digitrax connection with a PR3 interface and a DCS51 command station. All works correctly. However,

H_kane, Can you tell us what locomotive models you have from Bachmann? Even the Bachmann model number off the box? If those are sound equipped, you should be getting speed tables. If they are

Harry, It may be that the specific decoder that you have does not implement speed tables. Can you give us the details on the decoder model and make. Bachman has used SoundTraxx decoders in many of

Howdy Jack. In the log posted, I counted 76 roster DateModified errors and 15 turnout errors. Do you really have 76 roster entries? I have not had the problem with dates, but the format changed at

Hi Dirk Try removing the PBT from the circuit. I have programmed these just fine with a pr3 + ps14. They are best done by themselves without a second decoder being on the track at the same time. Steve

Terry Visit My Web site@ http://conewriversubdivision.yolasite.com/ Harry ? (You didn't sign your post) so just guessing I have a Bachmann 4-8-2 Mountain With DCC on Board and I am able to access

There are a couple problems indicated here. First, you seem to have some extra libraries hanging around somewhere. This is the “jackson” message you see. There something in the release note about

Ok. Let me pull out the LIUSB-Ethernet I have and connect it to a mac so I can check the port name assigned. That might take me a day or two. I moved recently and there are some things that still need

John, Metrics -- These are part of "layoutblocks", which is an extension of "blocks". The layout blocks schema is missing the metrics element. I can fix that. The default value is 200 which is not

I'm very new to this JMRI stuff so bear with me. I have successfully loaded JMRI and have successfully run trains from my laptop, I've even managed to run two trains at a time from my smart phone

John, I have been building a sample NX setup to test out your problems. I was able to re-create the "turnout" issue for sensors by not adding a turnout to the icon. After adding the turnout name, I

Good evening I have been observing this problem for quite a while and was hoping I might see a change in JMRI 4.8 but have not. It is an intermittent problem that occurs after confirming the Signal

Hi Rick I spent the day going thru' every print combination I could think of on Windows 10 and Windows XP. All of them came out as ~5 lines per inch, ~12pt courier, correctly sized and spaced, which

Dave, the turnout names are all there, and it displays the name at the top of the box, so something else is going wrong. Thaniks for looking at this. I am using the simulator if I hadn't said that

The problem I'm having when using the PR3 on my AVIO laptop running W10 is that when I look at the turnout table I can't find Loconet only IT turnouts. Yet when I change the computer to using Loconet

Thank you

John, You need to add a turnout name to the turnout icon on the Layout Editor panel before you can add the NX sensors to the turnout. Dave Sand

The difference is which CVs are index and which are data. T2CV: 201 8 bit primary index (first number) 202 8 bit secondary index (second number) 203&204 16 bit data Used for most sound things T3CV:

Paul; I have the Lenz LUUSB # 23151 The USB Green light The XpressNet Red light; which I believe refers to the fact it is connected

Good to hear you got Engine Driver working. You don't need to turn off the Withrottle server to Run digitrains, it will just ignore it. The IP address would be the private/local address of the PC on