开云体育

I started this thread over an article I was writing for the Trolleyville Times August 1 issue about a specific streetcar we were building using an old Q-Car shell, a modified Bowser RTR PCC floor and

OK, I found out after I did the Java 6 install, I had an older version of Java 8 on my machine. After Bob's post last night, I grabbed the latest version & loaded it. This morning I tested it & it

I do support a couple of layouts running on Vista with current JMRI. Java 8 will load, but you have to use the offline file it seems. I find the speed of Vista isn't great, on a couple of boxes we

Peter, Personally I'd like it if the 'you sure you want to create a signal without username' was something I could give a preference of 'don't bother asking'. Building the panels virtual the first

I am getting the same problem, and I know it isn't the command station or power Supply. I tried it on two different command stations and power supply's and get the same 308 error. How ever if I just

Hi Rich, Much will depend on whether you are able to get Java 8 running on it. That is the major JMRI requirement that you could run foul of as far as I can see. Wouter jmriusers@...>

Hi Thanks, got it. Created a new mast with no user name and I can "move" an old mast to it. Thanks again Peter

Certainly could be. For a long time, MacOS X came with the right drivers for the PR3; nothing needed to be added. But perhaps that’s no longer true. My PR3 does work with macOS 10.12.5, though. Bob

Jay - you indicate Java 6. You need Oracle's Java 8. Fred Sent from the Twilight Zone!

Jack, When you say you "close it and try to open it again later", are you referring to exiting JMRI and starting it later, or are you physically closing and later opening the laptop itself? If you're

Billybob, There are two more potential causes for the "JAVA Platform binary has stopped working" message when using a PR3: One is that if you plug it into a different USB port, Windows may think it's

I just dug out my old Toshiba Gaming Laptop which is still running Windows Vista. Are any of the current versions of JMRI compatible with Vista, and if so, would I be able to use current definition

I tried a clean install of both 4.6 & 4.75. Neither would talk to the PR3. Mac OS X 10.11 Java 6. JMRI launches fine & gives no errors after setting it to the right port. It sees the PR3, but will not

Could this be a Mac-specific issue? Another user has reported experiencing the same issue when he moved a working PR3 installation from a W10 machine to an iMac:

I did that a few times. Still (306).

Jack, That's a frustrating experience! Historically, the "JAVA Platform binary has quit working" message, when using a Digitrax PR3, is one of two things: PR3 firmware version or Windows PR3 drivers.

I can open Panel Pro the first time I start the laptop. But when I close it and try to open it again later I get the message Java platform binary SE has stopped working. I'm using a VAIO and the

Thanks for providing the file. That helps a lot. The largest amount of time was spent re-loading some parts of the Logix user interface as the sensors were loaded. Each time, the comboboxes for

Thanks for the updates folks.

I have posted a problem file named SensorLoad.xml in the yahoo group upload area (via Leo). This file contains only Internal Sensors. Windows 10 4.6.0 - manual load time about 1 seconds 4.6.0 - auto