开云体育

So you were able to rad CV8 with an NCE throttle, correct? Give us the system console. It under "help" on the JMRI start screen, on the bottom is "copy to clipboard". Do that and paste it into your

After attempting everything I could check & verify that things are supposedly in order; I still am getting this error message when I try to identify any of my 12 different locos. According to the Lenz

Mick, You are correct. I was thinking of "Idle" status, but for some reason my keyboard typed "Stop". In "Idle" status, track power is ON but control of mobile decoders is disabled. Thus, lights and

Wow reloading it totally worked, here I was scratching my head not able to figure it out, thank you!

Can you be more specific as to it's specs and the Dell model? Not only could we then tell you if it will run, if you want or need to upgrade it I could point you at the parts that will work for you.

JMRI will function on pretty much any computer that can run Windows XP and Java 8. I would recommend at least 1 GB of RAM.

Scott, I think Yahoo strips all attachments, but anyway I cant see your track plan. either post it in the files section with a title such as "Scott Meller's layout" or something that I can access, or

Follow this write up and let us know what yo find. Trouble shooting programming track problems DCS is you Digital Command Station GENERAL If you get short detected on the programming track (309)

To access the loco slots on a DR5000 you need to connect to it via a Digitrax connection. I normally connect via the USB port which allows JMRI to connect by both Loconet and Xpressnet and also the

I would like a hardware throttle (with a rheostat, and buttons) to control my SPROG test track. Ideally, it would be a simple device, maybe based on an Arduino, which would input commands to the JMRI

No joy here. Running W7, I have firmware 1.27 from the z21 monitor. I get nothing. Running version 4.6 throttles no good, but I could control points. Tim

Harold, I had a like problem but with some Digitrax decoders. I set up a fake consist on address 127 using some decoder numbers I will never use like 9999 and 9998. I leave them there all the time.

I get this error when I attempt to identify a new loco on my Lenz 100 system via wifi

You can upload your panel for the group to take a look at and see if we spot any errors. Something you can try in the mean time. Save the panel and reload it. Sometimes a restart is needed for the

I read the system requirements on JMRI site. I did not see anything about memory or processor speed. Are there any minimum requirements. My current machine is an old old Dell gaming computer I was

Mike, Our Elite support took quite a bit of work. Hor

Hi all, According to IOBit Malware Fighter JMRI contains a backdoor trojan in the following file "...\JMRI/\lib\x64\intelbth_x64.dll" on PC. JMRI version for PC 4.6-R81496dc Is this a

Thanks, Peter. Those changes looked good and were easy to pull into my copy. I've committed them to JMRI/EngineDriver. You'll want to update your repo from there (or refork) before adding other

Dave, Having read your advice in the link?NCE Consisting - Mark Gurries?I have the following question, which arises from a problem with consisting on my layout: ?As you say, when setting up advance

Paul, thanks again. I have re-posted the reply, as I see the colour I used in replies has been stripped! As for the memory being within the LH100, I agree that it has memory, but I don't think it is