开云体育

Maybe that wasn't around when I switched to warrants. www.jmri.org/help/en/package/jmri/jmrit/dispatcher/Dispatcher.shtml Warrants autotrain doesn't require a speed profile as it will create one if

It could be as simple as only allowing the station track to accept the express and diner cars.? Place the diner cars at the intermediate station. Now build the train and see if the express car is set

Thinking about it, if the bxp88 was powered by a 9v power supply and now is only powered from the track, that would also account for the different behavior. Steve G.

That was my mistake and has been correct in 5.11.2 on, it was confusing me as well as most every one else. I believe that is a setting in the bxp88, JMRI digitrax only changes occupancy on a change /

Thanks, this help. Programming going well. Still have issue with smoke unit. Joe Sent: Thursday, April 10, 2025 12:13 PM To: [email protected] Subject: Re: [jmriusers] Paragon4 (400a)

Dear Steve Some of my engines run extremely slow in automation and run faster with throttle control. My speed in the block table is maximum and my speed in create train is 200% maximum. Where else

Dear Steve I retried again today and automation worked. Hope my repaired bxp’s do not have an intermittent problem. The default when openning a create train is head only so yes the 3 allocations

Joe, I use POM for programming all Paragon decoders. I find them ‘problematic’ on a service mode programming track. Paragon 4 (and the later Paragon 3) decoders have CV217 that can be adjusted

I am trying to program an BLI engine I had upgraded to Paragon4. Sometime I program a section and it work fine and sometime I get 308 errors. Also I program one section and another section changes.

If you are not using a mouse, how do you move a cursor? Note: A touch pad / track pad is the same as a mouse. Dave Sand

Brett, Your configuration looks correct. While it is possible to specify up to four blocks, the normal process is to use one block for the first two entries and one for the other two

I do this successfully using Schedules for the station spur. ?There are games you can play using the schedules, custom loads, and car owner field. Jon in San Rafael

The program will only show hold cars for tracks that are serviced by only one train.? The local counts as one of the two

What does the cvsSwitchlists show? Dan

Set up my class yard Arrival track as a "Location".? It's length accommodates the longest trains I run. Set up Switcher (train) to PU at Location "Arrival" and SO at yard Location. When I tested,

Hi Members Could someone please help me out with A Single crossover and JMRi First things first. Please take a look at this photo of the Crossover I presumed that one turnout has one Block so A

Nags Dispatcher, when using speed profiles for stopping, does not use train length. Steve G.

That's the main reason I went with warrants, as train length is not used. Its methodology works on where the front of the train is and the speed of the train. It calculates from when a train enters

Peter, I did exactly what you called out for in Decoder Pro and I got back my roster. Thanks so much. Now my Operations Pro has lost my railroad and it was removed from the main menu. Any advice on

Evening, I am creating a set of passenger trains (A westbound and an eastbound counterpart).? I want it to leave its departure station and then at another station while making a scheduled passenger