开云体育

splasher,

Terry, Cliff He has his levers (IT) and sensors (IS) setup as "internal".? Isn't true that items starting with an "I" mean "internal".? If so these levers and sensors are not going to see any

Tom, Trust the JMRI Resets menu for decoder reset procedure, not "usually". There's no defined standard for resets. Doesn't even have to be CV8. The only NMRA requirement is that you must not actually

Terry, One further step that I intended to include in the previous note. __IF__ your DS64s are connected to your LocoNet, then wJMRI PanelPro running and - with NO panel loaded, - with with the

Stefan, The problem was that the raw DCC packet (M and P) commands expected a DCC packet minus the checksum byte, but that wasn't documented. JMRI NmraPacket generation code always creates a complete

Terry, With one huge paragraph to work from, multiple snippets have been isolated. It has taken more time to split out the details than to figure out if a response is needed. From what is written

How about trying a factory reset, Usually CV8. And usually a value of 0. Can anyone confirm this for this MRC decoder? Thomas Cain Indianapolis, IN atsf93@... See my NEW website and layout at:

Hi I programmed and read all my decoder with JMRI and printed out the sheets. Now if I have a couple engines on the track they both go. I checked some with decoder pro and they had the same engine

Dan, Are you getting any value for CV7 and CV8 in JMRI or the PowerCab? These are the keystone of identifying the decoder. It sounds like the decoder might not support readback which will foil any

Stefan, I can send you modified files, no problem, however it might be better to wait a bit. There is good chance the DCC++ BaseStation code does not have to be modified at all. Dave Heap was kind

I don't believe getting a newer version of JMRI would help. Dan

I have seen that for ESU decoders (especially v4/Select/V5) it is recommended (required?) to Read All CVs to determine the set-up, not sheet by sheet. However, when I do this I get a timeout before

Preamble, I generated a complete panel, layout, and tables for turnouts, sensors and logiX. When I put it on the working layout and made the changes in the preferences to Digitrax, PR4 and the Zephr

Tim, Any chance that you could send me a copy of your modified DCC++ library? I would save me having to copy and paste the above text and possibly mess everything up. I have a DCC++ base station of my

Dan, If you know what decoders there are in there (maybe after opening the locos up), then getting online to find the documentation for them shouldn't be too much of an issue. Whether JMRI can *find*

I bought two diesel locos from estate sale: Athearn and Broadway.? Both run great at address 03, but neither JMRI nor Power Cab can find the decoder.? So I can't even reprogram the addresses.? I

Mel CV21 = 0, CV5 = 0, programmed on the main and with my booster and nothing, absolutely nothing I've tried will slow down this locomotive. I tried various status edits with the same results. The

should I download and install a more recent version of JMRI and if so which one? I'm stumped - ck'd the print quality and it is set to Normal Gene

Sorry for the formatting of the last response, the log had lots of carriage returns in it, but then vanished when I saved it. -splasher in somd

Dave, I changed the Edit->Preferences->Roster setting that you suggested for "Confirm Writes by Read" to unchecked and tried the "Allow caching ..." both ways. I also changed the USB baud rate to 9600