开云体育

Thanks Dan Mike

Cliff Once again thanks for your help!!! I do keep the custom icons outside of the JMRI programs folder on my c: drive – I actually have set up a cloud drive on our Synology NAS (J:). Maybe we are

I asked Soundtrax a similar question about a used Walthers P2K engine, and received the following prompt and helpful reply: These decoders are based off of the original Tsunami decoder. I've included

Rodney, I think I see what the issue is. Thanks Clay

Bob, After a lot of interruptions a block of time allowed me to investigate at least some of what you have described. Unfortunately, I am not able to duplicate what you are describing with your icons.

Mike, I was able to fix your issue.? Mike had a local switcher that departed staging, serviced a location, and returned to staging.? The program didn't handle the staging track correctly for a local

Rodney, here it is. 2020-02-06 13:41:35,541 util.Log4JUtil??????????????????????? INFO? - * JMRI log ** [main] 2020-02-06 13:41:35,619

I have run into a very specific programming issue with Econami and Tsunami2 decoders: NCE PowerhousePro JMRI 4.17 or 4.19 (upgraded after I first had this issue. It did not have an effect) I cannot

I have a 25' RS232/serial port pass-through cable between my PowerhousePro and my USB adapter. It works without issue. Micheal Farley Bismarck, ND www.facebook.com/yellowstonedivision

...meanwhile the GP35 profile worked just fine for now...

Marc, He sent me same - so next step for me is to wait for the appropriate file to appear at: https://www.jmri.org/xml/decoders/ ? -Dan

Cliff and Marc: ?Thanks for the replies. ?Still no luck. I found COM 3. ?Opening the program's preferences now shows conn. EASYDCC via serial on COM 3. EASYDCC command station states: "controlled

Dear Marc, Yes they are in a consist. Broadway Limited units are 2 A units, Digitrax are 3 units, 2 FP7As and 1 F7B. Both these consists are run with all the units in the consist set to the same

Did same and got word from Josh levine? that they are putting the info together to update the Factory Installed Decoder listing for Walthers. He sent me a .doc file for the New York Central , a

You must write the selections out to decoder? via one of the four " WRITE " options or the changes you make will have no effect on decoder. If you try and close DecoderPro or the open? Roster

Just spoke with a helpful person at Soundtraxx.? He has to dig around a little bit as the CV info didn't readily appear to him, so I am awaiting his follow up.

I should also mention we operate every month and all of us over the course of a year have to travel 3 hours at least once so our sessions range from 2 hours when we are showing off our new toys up to

Hello, If I change a CV value from the CV tab in DecoderPro does it change the function mapping automatically if it was affected by the CV change? Thanks, Dick M.

Question, Does the Dispatcher perform the duties of the Clerk or is the Clerk a separate job on your railroads? If the Dispatcher does the Clerks job they already have all the info needed. If the

Hi. I just did a speed matching on two BLI E units, an A and B set in HO. Are you using JMRI to program? If you do you should use the speedtable. In the speed table you can adjust the individual