开云体育

I am no JMRI expert but have spent a lot of time on the site. ?The ethos here is you must demonstrate you have spent time trying to resolve your issue by (a) exploring the site and (b) describing how

THANK YOU. EXCELLENT. I am going to try it this coming week.

Sorry if this has been mentioned already. With the early Hornby decoders you could write to them but they couldn't be read back on a program track. It was also said that they would only accept a short

Hi All, I think I have it working now ... No need for any action ...

Hi All, I have created a panel in PanelPro layout editor. I have placed it in the problem files area DaveS directory. I am finding that some of the signal masts? have the 'Active' box unchecked?when

Thanks George, looks good. Andy

Bill, It doesn't disable "programming attempts". It disables "program track reads". Huge difference. That is correct, as far as "program track writes" are concerned. Both NCE and SPROG do "blind

Hi Dave, Thanks for the reply. I didn’t realize that having two engines on the track would disable the programming attempt, I thought that more than one engine on the program track would reprogram

There was a Yahoo Group called CATS-users@... The last message was late November, and Yahoo now has deleted all user messages as of December 14. So it would appear the only place to

If SoundLoader is working, try to make sure that JMRI is using the same settings (Port). Make sure you try exiting SoundLoader and restarting it too. If the issue is down at the driver level, that

Bill, They'll only be seen if fitted to a loco (or a motor across the motor terminals). They are possibly

i have been using DecoderPro for programming my DCC loco decoders (in all scales) for several years now, because the graphic interface is a lot easier to operate the trying to do programming

John, I don't have an answer to your specific problem, but your description of actions has issues. "I saved the panel from the My Panel window and from the signal head tools/table window." The panel

Just finished creating and placing signal heads for 10 turnouts, complete with very basic SSL for each head. All turnouts were working properly from the panel and the heads were responding

I have joined the group again after a hiatus of a couple of years.? I've still be putzing with JMRI and have progressed (ish). I am stuck on a couple of things.? I am having trouble with the

HI I got JMRI going onn my laptop with windows 10 and I made a roster but now how do I get connected to my dcc program track to program with decoder pro? I have a new Digitrax DCS Zepher Express

Larry, For the timed script you can run it from DP or PP. Using the timed script, you will find the loco drifts one way or the other over time. Using optical sensors, you need the additional hardware

Thanks Marc you just saved me couple hours of car time and the cost of a PR4. ?Interestingly, on a second try with the PR3/Soundloader setup on the PC I get a COM error message and cannot connect.

Even more simple is BackAndForthTimed.py. No need to sensors at each end. These are run within PanelPro? >? Panels? > Run Script? after you have started? PanelPro > Thread Monitor and? Script

Bob, I was able to get the browser view working. I had to change the style sheet href and disable cross-origin restrictions in the Safari Developer menu. The XSLT appears to work OK for most things.