开云体育

Upload to Files being worked on... Jim Bernier folder

Yes, I can print to a file.

That a different issue that I need to address: "Error on line 8: Attribute "commentColor" must be declared for element type "location" Can you print your manifest to a file? Dan

Andrew, Actually, if you wait long enough JMRI will make three tries to read CV8 in Direct Mode followed by three tries to read CV8 in Paged Mode, then eventually give up, with a 306 error, the Cab

Tested basic functionality of PanelPro & DecoderPro 4.17.8 on Linux Mint 19.2 with OpenJDK 11.0.4 ? ? Digitrax DB150 connected via a LocoBuffer II on a Lenovo X140e laptop Power On/Off, Loconet

Reinstalled 4.16... same problem. But I think I stumbled on something... when I try to validate OperationsRouteRoster.xml, I get this error message... "Error on line 8: Attribute "commentColor" must

Brilliant. Thank you. -- Steve 009 in UK

This is intentional. It’s due to the recommended wiring in Dr. Chubb’s C/MRI book. The two-bit-steady form uses the two lines to drive + and - to the turnout motor without any additional active

Sent from my iPhone Are you asking about functions? You said CVs above, so I just want to make sure. When you create an advanced consist via the consisting tool, it only changes CV19 ( sometimes

Bob - [Sorry for the long post, but I answer your question and I believe find another problem] First, answering your question:? last message didn't show enough of the monitor output: Turnout set

Hi Dale, A couple of things to try: 1) Connect to my demo server (jmri.mstevetodd.com:44444) It is also running 4.17.8, and works fine in my testing. 2) Check your JMRI System console for any ERROR

I was originally running 4.16 with the same problem.? Tried downgrading to 4.10 which is the version I run on my MBP without issue (different location, different printer)

Thank you Tony

Jim, You're running an older version of JMRI, 4.10 is not the latest.? Try upgrading and see if you still have a problem. Dan

Jim, And you can print a switch list for each location in the train's route? Can to send the manifest print to file?? Does that work? Dan

If you put double quotes "like/this" around everything if you're copying from a Windows command prompt, it will pick up everything.

I just installed 4.17.8 on Windows 10.? WiThrottle is broken.? I can start the WiThottle Server and it advertises it self correctly - on my system it is 192.168.1.75:12090.? I use Engine Driver on

Dave and Ken, Yes, what you described about the sequence and the Cab Bus LED fixing on is accurate. Also, after two tries to communicate, the two bits of text at the bottom of the Program screen go

Andrew Well I thought it was relevant, but obviously not, it was the 1st time I'd posted. Regards Roy

Roy, Roger that. No worries. i’m new too, and just learned something. Good luck, Andrew