开云体育

Marc, I believe you have interpreted the table in the SE8C manual incorrectly - something that I have done many times in the past; those tables make sense to the engineer at Digitrax, and perhaps a

Andy, The short flippant answer is 'coz that's how it was written' ;-) However, what should be the case is that each of the 'Add' dialogs provide (at least) three buttons - 'OK', 'Apply',

Hi Dave I've tried dev build http://builds.jmri.org/jenkins/job/Development/job/Packages/3551/ and all looks fine to me. Thanks for tracking it down and fixing it! As a side note, is there a

Chris, Which way are you powering the Se8c? I think if it is using track for power, it sees the turnout commands that way. Most people find it much more stable using a wall wart for power. -Ken

Wayne, In JMRI, a "Virtual Signal" is simply one which does not correspond to any physical hardware. If you wish to create a "Virtual Signal", using JMRI's "Aspect signaling" and "Signal Mast"

Wayne, Are you using sensors for your hidden track?? Have you created blocks with those sensors?? ?I use virtual signal masts at the junction between certain blocks for traffic control.? Dont

You don't need any hardware as the signals are virtual, that is they don't physically exist. The can be created either as heads or masts as there is a virtual option for both. All my buffer stops are

Hi Dave, Fix works for me, has also resolved https://github.com/JMRI/JMRI/issues/7458 Again thanks for your time on this, Steve.

Duncan, For each track that has a schedule, select none or blank in the edit track window.? That will remove that schedule from the track.? You can later re-select the schedule if you want to.? In

Guys, I am trying to setup some panels using Firefox Tablets. The first two seem to work fine. I was reading somewhere that I could add virtual signals to them. Can somebody point me to a tutorial?

Is there a simple way to turn all schedules on and Off? Just doing some experimenting with the program. *Duncan *

That makes good sense to me.? I will experiment and see if it proves out. Thanks Billybob! Chris

Steve, Andy, The fixes for this problem, along with issue #7458, have been merged. They will be included in test release 4.17.7. When the test release is available, please confirm that the fixes

You can not change the baud rate as it is a fixed value. Changing it in Device Manager will not help either, This bug was fixed in JMRI 4.17.3 but once the damage is done ( JMRI 4.16, 19200 baud)?

Chris, By default (according to the SE8C manual I have), the SE8C has its OpSw 14 set to "thrown". This means that the SE8C gets its control messages from the DCC track signal. And, if you have the

Bob,? that confirms one of my thoughts that it was likely picking up the NCE commands via the Rail Sync connection. But I don't know why it chose NT over LT and then changed it's mind. Thanks for the

The SE8c can take inputs from the LocoNet cable _or_ from the track DCC signal. It could be that it decided to use the track signal with LT wasn’t working. But I’m not sure why it would do

Strange behavior.... I just installed my first SE8C and during initial testing it would only respond to NT commands, not LT.? ?It has since resolved itself.? Wondering what would have caused

Hi Bob:? Thanks for publishing. I can confirm a FIX in JMRI 4.17.5 for problem encountered in JMRI 4.16. With JMRI 4.16 Panel Pro, clicking "Tools > Tables > Turnouts" would return the error

Ray, I recommend that you read through the tutorial while referencing one of the demo panels. "CTC Tutorial.xml" is the base ABS panel while "CTC Tutorial Panel.xml" is the completed panel. For SSL