开云体育

Thanks Ross, I have changed the opt. switches on the BDL 168 11 to closed and 12 to closed. Now i cant quite figure out where my railsync A wires go to on the BDL 168 board (which pin it should be

I just want decoder pro on this one and will run the panel pro version on my other Sprog pi one

Your Zephyr does NOT have a computer interface built-in, you need an RR-Cirkits LocoBuffer or a Digitrax PR3 or PR4. Simply put, you do need physical sensors but do not need physical signals. Not

I did not imagine a formal or lengthy process for gathering requirements - what I had in mind was spending a week or two asking people on a few forums about how they operate their layouts, thinking

Hopefully this will help in getting info to you that you can use to help me out. Digitrax DCS50 Zephyr 11-DS64 stationary decoders (power is daisy chained between all 10 for turnouts) 1-5 amp power

Great, thanks for the update!

This output is telling you that getCurrentReport is providing a DefaultRailCom object. When you convert that to a String, you get those last two lines (which will always be the same) But if you

You can’t run both DecoderPro and PanelPro at the same time, both talking to the same USB-connected hardware. So running them both at startup is unlikely to work well. Bob

Steve, After a long backorder and time off for the NMRA convention I finally got my RPi loaded with your software and everything is working fine. Thanks for making the "parts list" and "software"

Hi Steve I want to serve one up just for programming decoders so no need for any panels but cannot find the icon and executable for decoder pro which I also would like to run on startup Cheers peter

Gabor, Reading the manual on the detector, have you tried running the maintenance tool from Roco to test out and configure the module? Does it show the correct separation of the blocks? So first we

You could set up another desktop icon, but I'm not sure why you'd need to do so. Everything you'd see behind that icon is also behind the PanelPro icon. For the Roster view, just click the Roster

Hi Steve Seems to be working fine for me but cannot find the path to run decoder pro rather than panel pro Cheers Peter

Gabor, This is getting better. They have tracked down the issue with the initial reporter and have a code fix building to cure that. From the descriptions, it should let the system correctly learn

It will depend which JMRI method you call to Read CVs whether the enter and exit programming track commands are issued or not. I can't look up the code at present to check. Ken Cameron may remember

Scott, Another reference is the BDL 168 manual, section 6.0 BDL168 Installation for Non-Digitrax

Ken, I confess that earlier I tried two other major softwares and their forums without success. I havn't been experiencing there the helpful spirit of this group that I am vefy grateful for to all of

That is how the Cumberland West ran for a number of years. It went from all Digitrax, to NCE for throttles and Digitrax for everything else. David Parks was able to get the sync line from the NCE

Scott, Yes on all counts. A "standalone" LocoNet is what you are trying to implement. The info you seek is available in the JMRI help pages. For general LocoNet help, see

After presentation from Erich Whitney at KC NMRA I am trying to set up system with PowerCab to program decoders. ?I need to read CVs and then I need to run loco and adjust speed CVS according to