开云体育

Dave, I just did as you recommended. I downloaded and installed JMRI 4.12. I had been using 4.10. Thank you! Don Weigt

Don, I’ll add my apology to not responding to your request. Sometimes it is also too easy to think that others more experienced in these areas will take up your question. I see that you already

Garbor, One interesting thought, have you tried to use the Layout Power command? This would generate a sequence on the LocoNet that is frequently called a GPON, with is a set of codes that tells all

Ken, Many routers have a USB port. If yours does, an external hard drive disk or even a memory stick can be accessed by any computer on the network. For a Windows computer, the left side of the

Dave, ??? Yes from the loop back test.? I went into the website and have resolved that I likely need to send the unit to NCE.? Will call them tomorrow. Very frustrating ??? Now, the weird

I assume you are talking about the results of the loopback test? http://www.members.optusnet.com.au/nswmn2/Serial.htm <http://www.members.optusnet.com.au/nswmn2/Serial.htm> If so, the combination of

At the club, we have fine networking, it supports the phone throttles. But our two layouts and desktop programming/test station need to share the roster data. So far if you mention this, most point

Thanks for that. -- Dave in Australia

Dave, ??? I am seeing the "timeout flushes receive buffer:AA" Thanks Ron

I took that latest LocoNet log file and ran it. It created the sensors and reporters as showed in the text of the log. Running it slow, I could see locos moving from block/reporter to

From the command Monitor: Return software revision number 18:36:03.276: [AA]? Return software revision number 18:36:13.285: [9E]? Enter Programming track mode 18:36:23.294: [A9 00 08]? Read CV 8

Thanks for that. I'd suspect a connection issue at the 9 pin plug on the Power Pro. That would explain the one-way communication. Follow the instructions at this web page (a joint effort between

It's under the NCE menu and is called "Command Monitor". -- Dave in Australia The New England Convention 2018 http://www.newenglandmodelrailwayclub.com/content/convention.shtml

I am not using any program booster. But I ready N scale decoders.

All I have tried reversing the DC + and - at home. The power supply has been working just fine powering and running on the layout. One note that Paul did not say was that we did change the setting on

I hope this is what you need. thanks Ron 2018-08-26 17:30:38,633 util.Log4JUtil INFO? - * JMRI log ** [main] 2018-08-26 17:30:40,268 util.Log4JUtil INFO? - This log is appended to file:

When I find the clipboard, will attempt to get it all done. I opened the Help->System Console menu I could not find the NCE->command Monitor, although a black box was open and lines of communication

File replaced and updated to include class 60 stand alone tts chip and class 47 updated to include stand alone chip with CV 7 value of 132 Brian

Don, One other thing. I strongly recommend that you use JMRI 4.12. Dave Sand

Our HO club uses the N scale setting on both the DCS200 and PS2012 -- Peter Ulvestad JMRI Users Group Moderator - http://www.jmri.org ( http://www.jmri.org ) Tam Valley Group Moderator -