开云体育

Hello, I was wondering if anyone knows if i can set up my BDL 168 with my NCE system. I would like to run everything through JMRI. What are my options if my blocks are all tied to the BDL 168 but i

Dave, Yes seems to be OK in command mode. I have tried to solve this before and today sent an email to Andrew Crosland and Bill Chown. Have heard from Bill so will try a few things from him. Rick.

You will certainly have problems with JMRI and decoders (Paragon and QSI) that have Verbal Feedback enabled. The decoders go "deaf" while speaking and programming commands are ignored/confused during

That certainly is a strange problem but it could indicate an issue in the JMRI SPROG code. I don't have time to look into it at present. Just to refresh, did you say that you only had a problem in

I was aware of this tool, but was also aware that we had discussed updating this tool some years ago on the developers list because it wasn't fully compatible with current manufacturer practice. I

Hi After many months working without problems, the PanelPro has suddenly stopped sending commands (point operation) over the ethernet link to ECoS. The ECoS can operate any accessory directly thus

OK Great - thx - I looked at the loconet monitor (never heard of it before) and the 6900 and one other were listed as consist - did a "free", changed the 6901 back to 6900 and all works.? Thank

Hello George, For an outsider like me, it's still a bit thin on what you actually want to achieve, but for two things: 1) getting the turnouts to operate properly, and 2) operating trains with

Hi Thanks for responding. First of all my layout is not connected to the internet. So I cannot just play with my trains and get a help file from JMRI at the same time. All of my questions are after

From reading this and other threads with the power output from Sprog 3’s I’m beginning to think there is a wide variety of power supplies sold with them. Mine came with a 12.2 volt .5 amp supply.

PS? If providing an LNWI/JMRI option switch in ED is too complex, how about two separate apps - ED original and ED LNWI?

Steve: Might it be possible for ED to have an LNWI option in its settings? As has been pointed out, JMRI has features such as turnout naming that work well with its centralized nature in allowing

Dave, Thanks, I will check the console. Also would like to rephrase the question. When I open the test throttle, it does default to 128 and I lose full functionality of the speed slider. I can only

Forgot to mention: In that backup, specifically look at the built train at 11.45, Nelson freight west.

My yard's being weird, and I want to get to the bottom of it. My layout is split into 2 subdivisions with the Nelson division point yard handling a LOT of car movement (should be mainly block swaps,

JMRI has a “Dual Decoder” tool that can help with things like this: http://jmri.org/help/en/package/jmri/jmrit/dualdecoder/DualDecoderSelectFrame.shtml It’s a bit off to the side, and not used

This has been resolved offline. At my suggestion, Frank was able to determine that the decoder was locked as per NMRA S9.2.1. The key was that CV15 could be read and written, but no other CVs. This

Hi George, It's difficult to think in terms of solutions for your question (2-What are all the things that I need (sensors, transits etc..etc.) in order to get all this working for my layout?) when

Check the loconet slot monitor, and clear it there. Also make sure neither of the jump throttles have the address. Note that the zepher has slightly different options than the other command stations

To rephrase what Roger said, the PANEL needs signals, but they don't need to physically exist. You can use virtual heads, or if you think you may have physical signals someday, use an appropriate