开云体育

I have placed a virtual signal on that turnout and it now reverses as you explain, but I have noticed that it wont reverse if I select the final block in R4S4 (R4S4 only has two blocks in it).? Does

I do not know about SPROG, but one symptom you described reminded me of a oft-repeated problem. As I understand, in Digitrax, if a loco is not dispatched from one throttle, and another tries to

Steve, I'm not sure if its relevant to the above problem but I have been receiving "Crash Log" messages occasionally that do not remain on screen long enough to be able to screen capture.? There is

Thanks John. D.

Tony I have a program booster already to get past that problem it is a PowerPax. I have been trying a loksound engine in N-scale. Like I said before I took my system to my club and it works there. And

Hi You need a eastbound signal r4s4-r5s4. To try and make it less clear than mud, the Auto engineer is looking out the back of the train and needs to see a signal telling them that they can proceed.

Again, GOTO group.io web site The issue is well discussed. Try the various solution talked about. It’s about boosting the power and getting past capacitors or just try changing a few cv’s at a

Hi Steve, run it as you suggest but the message log doesn't appear to report anything untoward.? The only messages shown are of the form " *[AWT-EventQueue-0] VSDecoderManager.java:574? - Report

See below: You haven't told us the version and model of DCC system you are using with JMRI. This is very important information for this q

Derek, I did tell you the wrong order for one thing. When you place the second locomotive on the test track, write the full CV sheet first and when done go to the basic sheet and change the locomotive

Hi Dave, Thanks for the help that was the problem I relabeled all of my blocks, removed the validation override tool and restarted JMRI. It loaded normally. Phil

OK, I have had some success, but on, I assume, finishing “writing all pages” to the second loco my Mac seized up with the following error message at the bottom of the page (where the progress is

Ok in the last week or so this is what I did to trouble shoot this problem. I week ago I took my laptop and LocoBuffer- USB to the club. I hooked up to the DCS 100 there and I was able to read the

Thanks Steve that all makes sense and would be a wonderful addition to ED. I have a Kato unitrack layout which gets set up and torn down each time so I have a very simple turnout numbering system

Check the lower right corner of the main (all entries) window.? If "read only" is selected that exhibits the behavior you describe.? I've had that get inadvertently selected a few times. ? Rick

Thank you both for your time and efforts, I am the owner of the F45 Rick is working with me on Robert J. Richter 283 Elm Street North Reading, MA 01864 Sent: Wednesday, August 22, 2018 4:56 PM To:

https://www.facebook.com/photo.php?fbid=10217054666863870&set=gm.1829975590411830&type=3 photo of screenshot refered to in my email. (

Begin forwarded message: I clearly had no idea what I was doing when I tried to save my work. I spent all day doing it and saved it constantly but must have saved it incorrectly. Could you please help

Michael, OK. Some learning going on. All good then. SDP45/F45 will be just fine. Thanks. So it is TSU2 what it reads and has bulbs. Reads fine using NCE power pro cab (14 volts). Rick.

Hi all. I found a way to program my BLI Paragon3 decoders. I am using Vista Windows connected to my DCS210 via loconet-usb connection and using JMRI 4.13.2. I found if I select the Paragon 3 decoder