开云体育

You could also add the 'cross to wrong side' switch to all the signal mast logic, so it musty be closed (normal running) for each check. if it's thrown, things drop through to red [jmriusers]

Hi Steve, Thanks for your help, that was my problem I still had one section in the transit in the reverse direction. It was until you said to check that all directions go the same way and then saw the

OK, sorry I was not aware of that. The Version upgrading of the JMRI error message is: Error Opening file for writing: C:\program files (x86)\JMRI\LaunchJMRI.exe The error message in the

Has anyone used the AC_Powercontrol.py script in the jython folder? I have a Smart socket that I'd like to use to control power to the entire layout (command station, etc). I can currently control the

What error message? jmriusers@...> wrote: [Non-text portions of this message have been removed]

This group does not allow attachments. You will have to tell us what the error messages were.

Yesterday i decided to upgrade from JMRI 4.10 to 4.11.3. I downloaded the files and loaded the program onto my computer. Initially I believe the program loaded but when I went to "BUILD" a train in

Thanks Dave - that was something which had crossed my mind and then events had moved in a different direction... that should do it nicely! Many thanks for your help. John

John, If I understand what your are doing, here is how I would do it. 1) Create a virtual mast. 2) Attach it to a block boundary on the “wrong direction” track. Set it to hide when not editing. 3)

I've just upgraded to the latest version of JMRI 4.11.3+R80b3ab3 Now when I'm in Operations and I try to build any TRAIN I get the following error message and then Panel Pro shuts down when I

I am attempting to use some logix for a situation where a route diverges through several turnouts including two crossovers, effectively sending the train onto the oposite running line for reverse

John When using the Tsunami 2 or Econami - remove the PTB100. Gerry

Hello Billybob & John, I sent a reply at noon today, but don't see it, so I'm sending a new update via 'add to the conversation'. Sorry, I'm new at this Yahoo Group thing. I installed version 4.11.3

Randall: Which LocoBuffer? I have the older LB-USB and the FTDI drivers install for a serial device. Needed to do Google RR=Cirkits USB drivers... drivers for 10.4 (Intel) and higher. Reports

Jay, As Steve Todd has stated earlier, use a leading zero in your turnout numbers below #10 if you have less than 100. E.g., IT01, IT02..., IT09 Ken Ninomiya Oxnard, CA >>>>>>>>

You need to explain this box in more detail and tell us exactly what it says. It is quite likely indicating a problem that is preventing you from setting the defaults correctly. The exact wording is

Ken, I was not able to keep the change from "internal" to "Loconet".? I went into Preferences and made the change from Internalto Loconet.? But when?JMRI had to shut down to save the changes, they

Hi again folks Well, progress is being made at this end. I downloaded the latest test version 4.11.3+R80b3ab3 as suggested and then opened a withrottle on an iphone 4 running withrottle 2.2. I was

Hi Mike Thanks for the response. I've tried: s.dispose s.shutdown(socket.SHUT_RDWR) No luck so far. A lot of sites mention using: s.setsockopt(socket.SOL_SOCKET, socket.SO_REUSEADDR, 1) However I

Also consider using sensible user names for the turnouts. To simplify the display, use a separator (default is : ) and then you get them grouped by the prefix part. Great for larger layouts so you get