开云体育

Hi Dave,. Decoder pro works quickly and well. I think the following is important: Start DCC station Connect USB cable to Mac run decoder pro Then, following connection options appear under

Not real familiar with that code any more, but here are some thoughts (lots of log pieces dropped, you might have to go back to the earlier note for complete context) The timeout (1st line above)

From the NCE Power Pro manual: AIU BROADCAST ENABLE The system can be set to have any connected AIU (Auxiliary Input Unit) automatically outputs its status via the RS232 port on the system box

RJ, If you research the prototype, you will find they used a number of different ways over the years. And then if you add multiple tracks, trains that approach but back up, trains that stop, etc. it

Nick, Two things to keep in mind: 1. Most sensors do have some internal delay, at least track sensors do. Optic sensors are quicker usually. Which do you have?? 2. The delays tend to be consistent and

Ken B, Somewhere along the 4.7.* development cycle, we started pretesting the panel file and trapping errors like duplicates where they don't belong. In your case a signal LH82 is mentioned more than

Thank You Ken Cameron. Finding out that it is more complicated than operating a bull dozer! will continue to muddle along. RJ ---In jmriusers@..., <kcameron@...> wrote : RJM, It sounds

Hi, What are AIU broadcasts and what problems/symptoms should I expect in JMRI?. I only ask because I'm using NCE Power Pro 5, NCE AIU, sensors and JMRI script to measure speed of train going round my

Ken, What version of PanelPro are you running? The easiest way to diagnose this problem is for you to upload the XML file to the ProblemsBeingWorkedOn folder. Dave Sand

I did a prnt scrn of the error message and pasted it in this message but it seems it didn't stick so here it is. Parse error while parsing file

My panel file suddenly won't load. This error message appears. Any help is appreciated. Thanks, Ken

AIU broadcasts must be disabled for JMRI to work with NCE systems. JMRI does not listen for these. See point 5 at <http://jmri.org/help/en/html/hardware/nce/NCE.shtml#phpro> JMRI works by polling your

Hi, I'm trying to understand how OpenLCB node configuration works. To this end, I'm creating a working model, which I did have working up to having JMRI presenting the configuration panel. I adapted

Hi, I too have noticed that I can stop a train more accurately with a throttle than with a sensor using a JMRI script and an NCE Power Pro 5 and an NCE AIU. The status of the AIU is not sent via the

Waz, since I did the original post I have ripped out the BLI decoder and replaced it with a Soundtraxx Econami 200, part number 881102. I don't like the BLI decoders as they are prone to fail, the

Thank you for this. I will try to find time later today to try this out. We have a public awareness event tomorrow and I was hoping to have the small railway shunting yard we have as part of that but

Hi Charles, Firstly which decoder type did you use? as when I try and add the loco to my Roster it returns error unknown decoder. And secondly have you had any luck with changing the Lighting CV

Hi, I too am new to jmri scripting. I think you are spot on to start with something simple. I did the same. With regard to your question, I have two comments that hopefully may be helpful if I have

RJM, It sounds like you are asking about the typical road crossing a set of tracks. As pointed out, there are many ways and combinations of track so a one-size-fits-all doesn't exist. Another issue is

Sounds like the Consist settings for 5629 are not "Locomotive Address Only" for Lights and Bell. What brand and model of decoder? Read the actual values in CVs 21 & 22 and if not already so, set them