开云体育

The only " EDIT "? possible is? " DELETE "? on this forum, unfortunately. using that? 'MORE' button Marc

Steve Thanks a lot. When I click on the crossover on panelpro the 2 points work correctly. When I run dispatcher, dispatcher always sets the points to direct? and the white line has a break in it

... Unless there is a problem with one of the sockets:? bent pins/contacts within socket. Marc

A little lost here.. You have a PR3 AND a Digitrax DCS52 ? The DCS52 has an integrated PR4? in it which you can connect to via the USB connector out back. There is no need for the PR3 with the DCS52.

I'm still learning and setting stuff up. Some advantages I see over CC/WB, setting train limits, and car rotations. As operating on JMRI layout, it allows specific lengths that the owners have defined

Hi guys I try to learn how to use mast signals in my? LE layout? ? .I build a small layout? from? 4 blocks? ?. For some reason with no success? when i try to run the dispatcher? .I uploaded?

Doh, got the throttle going...forgot to throw my with to power the track...guess I am into the New Years Scotch too early!

Cant seem to edit my post, by Locate port I meant Loconet port. Thanks, Craig

Hello, Finally some success! Changed over to hooking it all up through loconet and the Digitrax DCS-52. I had tried this before, however this time I changed the locate port on the PR3 to the left one.

Craig, It can be frustrating no doubt. It's all about getting and using what is proven. In this case you don't need a lot of processing power just components that are proven and known good. JMRI on

The grid drawing code uses LayoutEditor::getZoom() to scale the visible rectangle to the clipping region… and getZoom uses: public double getZoom() { return getPaintScale(); ? ?//<== accessor for

To check the proper address of the port: 1) _Without_ the device connected, restart the computer. 2) Start JMRI. Look at the preferences and write down (or take a screen shot) of the existing ports.

Hi Inobu, I tried a pc as I have one that is a Math buster from my business (renders illustrations for billboards...lots of power) With that I had a tech install additional ports and then had com port

At this point, if I had to guess, I'd say it's most likely an issue with the fact that the grid drawing code uses the setClip function, but the scroll bar adjustment code uses the setPaintScale

Bill If you "click" on the crossover do the 2 points set according to the layout panel display?? Having 1? switch for both points or 2 separate switchs should make no difference, providing they are

Dale, thanks for the info. I will look for the consist file and try removing it. Won't be able to get to it before Thursday. I will let you how it works out. Thanks again Dave

Thank you! Glad the Mighty Mouse is working. That was a real head-scratcher. Bob

You could try a Matrox Duallhead2go which allows using 2 monitors as though they were a single wide monitor.? Matrox also makes a triplehead2go that does the same with 3 monitors. -- Dale Gloer

So you removed the setClip code and it can handle large layouts now? That's pretty good news, since it's been an issue since version 4.9.5.

Actually what happens is when dispatcher is called it sets up the route, it all goes white from the bottom left to the top right. The point moves, The diagram on PanelPro shows a broken route as the