开云体育

Hi Paul, Great news you got it working. To your issue with Build Failures, remember you can always put virtual staging tracks at each end of your JMRI Ops railroad to give all the cars enough space to

By the way, Breezly. That setting was shown in the build report so you were right, the problem was identified there. Thanks, Everyone Paul

Looks like I found the problem! In train build options, "allow cars to travel from origin to terminal" was checked. By unchecking that the switch list gave me orders to swap an empty for a loaded

Off the top of my head is font changeable on manifest as to size of type it may just be the matter of a couple of points causing the issue.

Hello. I use an Epson Work force WF 3720 ink jet and the PDF prints just fine. But the manifest is one line to large and the bottom line is a one/half line as if the bottom half of that one line is

Breezly, I just built a train from a staging track which contained one loaded flatcar. There is an empty flatcar on the spur in question now. I would expect the switch list would have me pick up the

All, Was moving my updated JMRI layout file from my notebook over to my raspberry pi and noticed after bootup that the block values were missing.? So I assumed that there must be some other file

Charley, The top of each column can be clicked on to arrange that column in either ascending or descending order. Each click will reverse the order. [email protected]> wrote: -- John Griffin

Breezly seems to think the answer may be in the build report. I am not familiar with these as a beginner but I will look into it and see it there is something in it that helps me find out what's going

Thanks, Dennis. I have already checked that, in fact I added length to the spur to be safe :-) It did not help. Thanks Paul

Thanks for the reply, Bob. While I do appreciate the help you are the third person to tell me to set the move count to 4. If you read my second post you will see that no scenario calls for more than 2

My Roster has some locos out of numerical sequence.? Using? Win 10, Lenz LZV100, LH100, LI-USB.? How can I correct that? Charley Goddard Muncie, IN

What brand and model of printer do you use? Laser, ink jet or antique dot matrix?

As a work around print the P D F and see if it prints on printer ok.

Hello Paul, JMRI Operations adds 4 feet to the length of each car to account for the couplers.? Make sure the spur length is long enough to hold both cars.? Hope this helps. Cheers, Dennis Drury

What you want to do requires the location/spur to allow 4 moves. The act of dropping a car is a move the act of picking up a car is one move so it takes 2 moves to drop and pick up a car 2 cars = 4

Frank I use three printers during a session. All my paperwork is Excel generated so I use the "fast draft" setting as to print quality. However, if I forget and do not change that to normal when

Hello, This email message is a notification to let you know that a file has been uploaded to the Files area of the [email protected] group. *File:* Test Bed Dale Trial.xml *Uploaded By:*

Hi Dave. Many thanks for your help re editing connections. Got the hang of it now and started to create a panel including part of the layout. I have used MERG parts only and entered these as hardware

This sounds like the printer has a problem printing close to the ends of the page. This is common with older laser printers where the printer cannot control the ends of the sheet to maintain contact