开云体育

Klaus, In my previous msg I said: "Interesting, for as far as I can tell I have not had?<engine-gain>0.8</engine-gain> in the config file.? I have now put it in and I think it has made throttle

I'm unsure of what "new" clock functionality you are referring to. Clocks have been in JMRI for years. Click on tools followed by Clocks and then Setup Fast Clock. from that screen you can get online

To Clock people, I have tried to keep up with the clocks development but I got lost somewhere - 1. Is the new Clocks functionality in the current test release? If so, can I access the computer clock?

Hi Steve, ?????? I have uploaded the full file. I do not know about CAN simulation as I have not been involved with that. ?????? I have been adding lights that are used on the club's layout. ??????

Bill, Are you doing your testing using CAN Simulation? I was able to re-create the problem using CAN simulation. When I activate a route, JMRI hangs waiting for a response from a CAN command. If I

Dave, There are NO track “icons" on a layout editor panel. Everything is a set of lines drawn between xy coordinates. A level crossing has two Ines. A regular turnout has at least 5 lines, one of

Bill, I will review your proposed changes. Those look like very good additions. Dave Sand

Frank: It's in the Google Playstore where it's fully described. https://play.google.com/store/apps/details?id=org.za.flash.wifiprioritizer Jan

Klaus, "You can save your throttle layout, see the File menu." I did save the throttle and that solved the "track slider in real time" problem.? Thanks Yes, I did check that F8 was correct.? Program

I have tried to set up some NX routing, but have found that JMRI crashes after I click the first NX sensor. I know NX routing works because I saw it demonstrated successfully at a cource run by Pete

I have found YATT very useful, and have used it in my club to move a train around a timesaver puzzle. Thanks Dave Sands very much. I found that I needed two enhancements in order to reduce the size of

This update worked, it read the decoder, i saw the engine lights flash and the link light on the MRC system flashing too. I also saw the traffic in the MRC monitor. It did not progress to the "next

Does the Intellibox have RailCom enabled ? If so, try with that turned off – my experience is that several Digitrax decoder types don’t like RailCom. I really doubt that there is a change to the

UPDATE I have fixed this. The reason was a large number of spaces was slipped in the start of the messages destroying the formatting stc. I cleared these and now I can read the HELP file properly.

Thanks for your swift reply Dave. Point taken regarding the number of variations on the market. I still have a problem of viewing the HELP info below the layout. I am using a Surface GO laptop in

One other little gremlin I have noticed when using Monitoring, is that an external poll of the switch status may cause an incorrect state to be displayed on a Layout Editor Panel for turnouts marked

Dave, If I may, I would comment that the ability to create a Double Crossover using 4 turnouts and a Diamond Crossing would be a great help as would the ability to have a smooth transition/join

Hi Dave Sorry for the delay in replying. Was away yesterday. I have set up as you suggested and what I am finding is the HELP info below the layout display appears to be greater width than the main

Conrad, A left mouse click above the slider handle should increase the speed by one speed step, a click below should decrease the speed by one speed step. You can save your throttle layout, see the

Hi all, I (and others) have this issue with various digitrax decoders. (DH123D, DH126D, DH166MT, DH126MT, DH165LO, DN136D, DZ146PS) When running them on a uhlenbrock intellibox command station the