开云体育

Perry, I think you have it correct, now.? CATS is an add-on to JMRI.? The turnout and sensor tables can be created in PanelPro (JMRI).? CATS is used to as an alternative to Layout Editor or Panel

My understanding of the design was not to broadcast events that were not being listened for. The ideal was to save traffic that wasn't needed. The result is any client must support the protocol for

Group, I just posted requesting input for moving to NCE, detection, and signaling. However I do have a question. My yard is currently controlled by panels connected to Digitrax DS64's that control all

Group, I started out in DCC with a NCE system several years ago, but switched to Digitrax because they had components that made signaling simpler by?using their products. I've used?JMRI for years

Friends, I responded to an email on the group when someone requested help for a friend. I inadvertently mentioned a "Lokprogrammer group", when I was referring to the Loksound group someone already

Marc, Here is the log file: 2019-09-13 10:48:26,031 util.Log4JUtil??????????????????????? INFO? - * JMRI log ** [main] 2019-09-13 10:48:26,296

I have exactly the same setup as you (PR3, PTB100 with 15volt 1 amp supply, Windows 10 laptop running 4.17 in Direct Byte) and only have an occasional problem. One thing I haven’t seen mentioned is

Hi Tim, If you could upload a non-working panel file to /g/jmriusers/files/ProblemsBeingWorkedOn/Updated%20Lights%20-%20Testing I'll certainly take a look. Is this reproducible in CAN

It looks to me like the address keeps truncating. It’s ‘loksound-subscribe@...’ -- Mike Heintzman Modeling the P&PU since 1953

I subscribed at: Loksound-subscribe@... -- Mike Heintzman Modeling the P&PU since 1953

I am ready for anything I think they where one time errors as thankfully? I cannot reproduce them The black tower can be held for a long time its just warm. I am ready for any test! Thanks again! Luke

Dick, This is not exactly true.? You are correct, that if a 'request' has been received for a particular clock event, the clock is to always send that event when appropriate.? While the clock is

I have used sensors with my DR5000 with a Lenz connection. These were not with the LR101 but with LDT RS16 units. I found you have to make sure the start address is set correctly or the addresses will

Michael, Does your experience reported above match the recommendations as per the JMRI Hardware - Digikeijs ( https://www.jmri.org/help/en/html/hardware/digirails/index.shtml ) help page or should I

Hi Matt I can confirm that it now behaves as expected. Best John K

Hi Stuart & Dick, Thanks for the replies.? I had assumed JMRI would not just send LCC frames unless there was an LCC connection and a clock slave on that.? But at this stage of development, the doco

Nick Excuse me for you mail was not address directly to me, however as an enthusiastic lockprogrammer user I wish to be in contact with the group John Pearson

I would like to get on the lokprogrammers group Ken Moordigian Jackson Livery 818-522-4292

I understand. The JMRI form that says cTc on it is still only a JMRI form. One must specify the panel to be started in the Dispatcher panel window. Nothing like a band new user to run the monkey test.

Mike, If it indeed is the case that (as suggested by Spuds McCat) you have 16 and 32 bit versions installed, that's not a problem. JMRI will pick one or other. Some other software may require one or