开云体育

I've been using Android tablets for a couple years with much success.? Most of what I read in previous posts is right on.? I have as many as 19 panels available on about 10 tablets around the

The good news is that the basic pausing seems to be working fine in 15.1 and I'm now refining the use of it to control trains with a fair degree of success. I think it was in one of the 13.x series

Don W, I've written panels over 5000 wide and 2000 tall. Takes a lot of scrolling for some of the tasks. By design, I'm not sure there is a limit on size. Granted it does get a bit awkward as they get

I realize the panels are unitless, so the dimensions aren't "real". But, there are the issues of how coordinates are stored, so JMRI probably has some grid and panel size limits. Likely limits are

Hi Andy, Just took the time to read that little saying after your name. Pretty funny. Gordon Spalty

Thanks for the reminder. I am just concerned that realistically modeling and operating trains (and using JMRI ) was becoming much more focused on having substituted wireless mobile 2D approximate

Think I have worked my way thro that problem, now some of the throttles created will not save the changes I have made ? Any suggestions please?

I don't know where we're at now with the MQTT extension proposal. There has been some discussion and ideas floated for using JSON format for the payload. Here are more ideas using JSON. I don't know

Hi Guys hope you all had a good hols? With some time on my hands I thought i'd put it to good use and play with jmri. The subject creating throttles and assigning the correct labels to the buttons

Many thanks Paul, I look forward to the fix. Meantime Happy New Year to one and all. Tom

This happens because you are using a Compact which doesn’t provide support for sending raw packets to the rails. BUT you shouldn’t get this Error message because the command station option should

It goes by so fast it’s hard to catch under normal conditions. One way to see it is to power off your C/MRI node while JMRI is running (also works to unplug the RS485 cable). The node will stop

I feel like we're going around in circles now ... I had accidentally knocked the power wire off of the rs232/rs485 board ... reinstalled and everything was back to original problem ..as stated in

I've seen that happen as well. Fix for that is to attempt to delete both and normality returns (probably after a roster rebuild). -- Dave in Australia

They have the new controller (DC240) and new transponding devices and occupancy detectors (BXP88, BXPA1) in near future? Our club is getting ready to refresh the equipment and we would like to know if

Show Quoted Content Yes. Use one of these: https://www.dccconcepts.com/product/cobalt-s-lever-single-pack/ They have electrical switch outputs, so you just connect those to JMRI as sensor inputs. ( I

The prototype requires 3 dimensional grabbing and pulling, rather than touch. <http://zenithcity.com/wp-content/uploads/2017/04/2L-Central-Ave-%C2%A9-Twin-Ports-Rail-History-by-Jeff-Lemke.jpg> I'm

I don't have a size problem on my iPad. Don't know if this applies to other tablets or not. My panel is about 1 screen high and 4 screens wide and I can slide the panel around very quickly with my

I was surprised recently when I was running several tests with trains going into/out of staging.? My routes for this train pair (north/south) show 25 "moves" into north staging, and 25 "moves" out of

Just loaded 4.14 on back up laptop to look at and try and got the following errior The content of element type "options" must match { train options {row color options { traineditoptions