开云体育

Assigning CV15 to any value other than 2 has no effect, the motor decoder doesn't work. I know the motor is getting power because when I place it on the programming track and program the motor gives

Hello all. I have been using CATS designer and CATS on my Laptop for some time and recently designer will not start. CATS will start no problem. I have reinstalled the files for designer with no luck.

The quick-and-dirty approach is to put your new file in place of the old, with the same name. Which editor is this? If it’s in Panel Editor (or in Control Panel Editor, and you open it in Panel

Bob, Dave Sand got the story correct while this was being typed!! ----- From the appearance only, since you did not provide the actual panel xml file, one is left to surmise that you have put the

Bob, Without looking at the panel xml file, my first guess is that you set the image to level 1. Although my panel editor experience is limited, I seem to recall that level 1 is special. If that is

Hello, Please refer to file CTC PANEL.PNG in folder Bob Z CTC Panel. I've built this panel using Bob Bucklew's tutorials. It's been in use for about 4 years and works great. I am currently in the

PJ, When your friend upgraded his system, did he also upgrade to a newer OP system. W7 and W10 have different file structures so if he is using an older panel, the file locations for the resources are

Thanks Dave. Does sound like progress. John

I tried to talk him though it but he got frustrated. I'll have to go to his house I guess.

That information is also stored in a log file ( see below). So yes that was what I needed. Now to the important bits of the log. This is actually an improvement. This indicates your Mac is talking to

Harry, Keep in mind that the address change (.2.2 to .2.3) was due to DHCP of your access point. Unless a node is configured as 'static' in the DHCP server, it will change from time to time due to the

P.J.: Was this a clean install of 4.8.0 (4.9.1?)? I've never seen a decoder go away but the JMRI will know that better than I. If you brought over older version of JMRI or the data from the old

We need more specific information about which decoders appear to be missing. There could also be a problem if your friend has been adding custom or prerelease definitions. In this case an

There are some issues here: - ESU decoders also need CV15/16 locking enabled (bit 1 of CV 124). - TCS decoders treat CV15=0 as a "universal unlock key" for a decoder, irrespective of the value in

Hi Randall It's obvious when you think about it, isn't it! I had set them both to 12080 assuming they should be the same - but they're obviously not! Changed the web server port to 12090 and it works!

Initially, both decoders received power from all pick-ups. But this problem occurred so I disconnected them. This gave me the added benefit of programming one decoder at a time in case the lock didn't

System is Windows 7 using JMRI 4.8 though I am not sure the JMRI version matters. Using a DCS240. Connection from PC through locobuffer to the 240. JMRI only finds 2 of the 5 UR92s on the layout.

Pcgumshoe, I would think there are several issues here. If you have front pickups going to front decoder only and likewise for the rear, then if you have track issues, only one decoder is getting

Ken, Unless I reported otherwise, the switches I listed were "non-shorting" switches. But if you are using a 30-degree-indexed switch for a 60-degree-indexing or a 90-degree-indexing application, then

A friend of mine just got a new computer. He is having two problems. First we set everything up for his Panel Pro. But when it comes up all the switches come up with the Unknown Icon. How do we get it