开云体育

So Dave, should I continue to try reading all CVs when I get a new (non ESU) locomotive? I’m just concerned I’m somehow altering what’s in there (example getting wrong addresses, Vhigh values,

Marc, We can't guarantee the accuracy of JMRI defaults for any decoder definition. We only go by what is published, which is not always accurate. Even if one of us has an actual sample of the decoder,

Tim, Preferences->Roster->Programmer. Dave in Australia

Am 13.09.2019 um 21:19 schrieb Stephen Bartlett via Groups.Io: If you have running DecoderPro, there is a possibility to change to PanelPro: navigate to the File dropdown list, then select Open

Thank you, I will try these. Ken

Re the discussion quoted below: I do not find a Debug dropdown list on my installation of Decoder Pro It appears in PanelPro, and lets me click on Virtual sound Decoder and then VSD Manager. But then

also, how long should JMRI take to read a decoder and the CV's? Thanks again

Marc, Both the sys-7 (main track) and sys-8 (program track) settings are at 009, therefore cabs 1-9 can program on the program and main tracks. Then my interface should be able to program. Am I

Thanks Mike, good to know someone else has the same setup working.? I have no idea where "Read after Write" is enabled or disabled, couldn't find it going through preferences, comprehensive

My JMRI version 4.17.1 is configured for my Roco Z21 command station and the latter is configured to send both CAN and (emulated) LocoNet feed-back messages back to JMRI. As I understand, the 'CAN

Marc, Thanks for help. I have set the JMRI cab to 2. As for the LAST CAB issue, that is next on the list. I also am wondering if the "master cab", #1 is only allowed to program. I am going to try

Ken, This is partially correct.? We do still need to periodically broadcast a time event so that time clients that are tracking the progression of time internally do not accumulate time drift away

On my last layout I used NCE for train control and had a stand-alone LocoNET for other things. On the current layout I still use NCE but have made the jump to LCC. Tim Rumph Lancaster, SC

Perry, I think you have it correct, now.? CATS is an add-on to JMRI.? The turnout and sensor tables can be created in PanelPro (JMRI).? CATS is used to as an alternative to Layout Editor or Panel

My understanding of the design was not to broadcast events that were not being listened for. The ideal was to save traffic that wasn't needed. The result is any client must support the protocol for

Group, I just posted requesting input for moving to NCE, detection, and signaling. However I do have a question. My yard is currently controlled by panels connected to Digitrax DS64's that control all

Group, I started out in DCC with a NCE system several years ago, but switched to Digitrax because they had components that made signaling simpler by?using their products. I've used?JMRI for years

Friends, I responded to an email on the group when someone requested help for a friend. I inadvertently mentioned a "Lokprogrammer group", when I was referring to the Loksound group someone already

Marc, Here is the log file: 2019-09-13 10:48:26,031 util.Log4JUtil??????????????????????? INFO? - * JMRI log ** [main] 2019-09-13 10:48:26,296

I have exactly the same setup as you (PR3, PTB100 with 15volt 1 amp supply, Windows 10 laptop running 4.17 in Direct Byte) and only have an occasional problem. One thing I haven’t seen mentioned is