开云体育

Hi Steve. I have a Digitrax system DCS 100. By reset I meant that I cleared the command station including all loconet address slots. So it was a complete refresh of the system. If I try to address

Hi John, what does "reset the command station" mean exactly? What CVs did you reset? Also, what happens if you try to acquire those addresses individually, not as part of an EngineDriver consist? I

So another problem. I want to form a 3 engine consist. 3120, 3121 and 3123. I can access 3123 fine but every time I try either of the other 2 engines I get a steal?? message. and cannot steal either

Never mind on this one. I figured it out. It was a preference. I had the 'Drop loco before acquire' checked. Unchecked and all is wonderful once again on the Maryland and Western. Thanks.

I'm running a Digitrax LNWI and using v2.20.57 of Engine Driver. I cannot create a consist. I followed the directions in the ED help but it's nothing like the help says. I used to create consists in

Got it! Thanks Dave, I wet my pants for nothing.

Thanks Steve, As well as internal sensors working between two external sensors, will sections of track with internal sensors work between points?? Do you still have to write logix for these

In the most recent version(s) of that script, there are lines near the top that says: # set the intended LocoNet connection by its index; when you have just 1 connection index = 0 connectionIndex = 0

I want to use the InitLoconetSensors.py to check the state of all switches and buttons on my control panel. ? ?I have multiple loconets on the same computer, how can I make InitLoconetSensors send

Christopher - thanks for the link. Very clear instructions. Now I know where to go to find help info. Mark

Steve -Thanks again. Didn't realize that was a server issue rather than an Engine Driver issue. You hit the nail on the head, Turnouts were disabled in my WiThrottle Server set-up. Good to get

Sorry this request has no context. There is no one unique NCE test. The test I am asking Steve Jackobs to undertake is for a specific problem I have observed from the JMRI logs. It's not suitable for

Jon, I will add your request to export locomotives. Dan

Steve, I've been asleep over here and will do so offline later today. I have personal family commitments to attend to first. -- Dave in Australia The New England Convention 2018

Hi Graham If you are using internal sensors then you have to write logix to turn them on and off. Generally it can be made to work with an internal sensors between two external sensors, but I've never

Dave, Please send the offline steps to test NCE uniquely. Thanks. Bob

Graham, ? ? There is a box in the New Train window that has the loco stop at the end.? ?The first section and last section of the transit should be the same for this feature. Roger

Hi All, I have changed from signal heads to signal masts.? My train goes around the loop in Dispatcher automatically but doesn't stop in the station as I want it too.? The 3 physical sensors show up

Is there a way to print or export the locomotive roster in ops such that consisting and other fields are available?? Consist, weight, and horsepower are not available except on the Locomotives

http://jmri.sourceforge.net/help/en/html/tools/Turnouts.shtml