开云体育

It much depends on the deadlines. Im currently unemployed so now i can dedicate time to this, but I cannot guarantee the same dedication in case i get a job, sooner or later. Which is the tipical time

Dave/Ken, I'm sure you understand your exchanges but, for me, they may as well be in Chinese!.? The bottom line for me is, once I have v1.65b software in my SB3a, will JMRI receive the signals from

My guess is that the 0x8A command uses the CS Memory Block to compare/store the last polled state for the AIU, hence populating the last two bytes. It's possible the Power CS does actually poll all

Well I figured it out. I had defined the cars as 'passenger' in the drop down menu under the cars menu but I had not checked the box underneath the drop down which has a list of passenger, caboose,

Tried the Power Pro and the only difference was that it used the 0x8A command instead of the 0x9B command and got a 4 byte reply instead of a 2 byte reply. There were no memory read commands from

Dave, Yes I think I may have mixed up the parts. AIU, ok, accessories no. The other is that I think the USB version only polls the AIU's it knows about. So the sensor has to be created first. But the

Possibly so. I'll check my Power Pro. Did you try my procedure with a real AIU and whether it detects connection to ground of the nominated pin? -- Dave The New England Convention 2018

Dave, I'm suspecting that is the difference of the two commands. The one in turn polls the AIU and passes back the data. The other command reads the AIU buffer in memory. The CS02 has the memory

Hi Folks BDMRR is having the same problems described after JMRI upgrade with essentially the same system components in place: W10, DCS100, PR3, WiThrottle and Engine Driver John Stewart Birmingham, AL

Ken, I just tried adding an NCE Sensor to my Power Cab profile following the instructions at the second link below. I entered 8:2 into the Hardware Address field of New Sensor, pressed Create and my

I may have mixed up cases here, it has been a while since I was regularly deep in the NCE code. Now what I did see looks like some of the code is there for the other command, but I don't think it is

The example jython folder that Bob Jacobsen identified earlier in this thread seems to be an excellent, if well hidden, starting point for what you have described. The README file is a must. Just wish

I am a member of the Garden Spot Village (GSV) Train Club located in New Holland, PA where we are running Windows 10 with JMRI version JMRI.4.10.R419243 connecting via a Digitrax PR3 to a Digitrax

I haven't checked the code, but are you saying that the existing AIU code doesn't poll the AIU itself but looks at an AIU memory block (or are you confusing this with the turnout position memory

Turnout position memory in the command station memory is only applicable to Accessory Decoders, not to AIUs. However, the long form AIU command does require command station memory and that would be

I think the Arduino file got corrupted and I need to reload, but I cant find the file I previously used which simply read the digital input status on pins 7 and 8 of the Arduino and using the CMRI

Just want to send Arduino ?input pin status to JMRI.

Ted, Ok, it seems you had the audio library issue, now taken care of by that file. I'm not too familiar with the Arduino and how it connects, so I'm not much help there. But if the other pc is able to

Kn, Here is where I stand presently. I placed the file you provided?in my JMRI Home directory and now I am able to load JMRI panels and all and access all my tables sensors, routes, turnouts, etc.

Darren, The right click context menu option was only available when the Layout Editor panel was in edit mode. When I updated NX to support cross-panel routing, I removed the context menu option so