¿ªÔÆÌåÓý

  1. Jmriusers
  2. Messages
Single Messages Topics Expanded Polls

Re: NCE ProCab- Light-it as signal decoder - Simultaneous commands #nce

 

¿ªÔÆÌåÓý

Ken,

From my POV. I don¡¯t believe I have had any masts change state that were not addressed.?
The only signals that didn¡¯t respond were directly addressed, ignoring the command when a route flipped a turnout.?
This is Al¡¯s issue, so I¡¯ll sit on the side and monitor.
?
John ?Bauchiero
-?NCE PH-Pro & PowerCab, Pi4, DCC-EX
- JMRI 5.11.5
- Java 17.0.12

On May 5, 2025, at 6:03?PM, Ken Cameron via groups.io <kcameron@...> wrote:

I have an important question about those using the Light-It as a signal decoder and having trouble.
?
Can you test, or have you observed, signals changing in parts of the layout that should not be getting any commands addressed to them?
?
Also, about the logic these people are using: Is a change in a single block causing a change (directly) in an signals not directly protecting that block? A signal changing in response to seeing another signal change is considered for this question to not be a direct change cause.
?
-Ken Cameron, Member JMRI Dev Team
?
?
Join [email protected] to automatically receive all group messages.