Howard,

?

You said you did test it from the turnout control in JMRI. It was responding to one address but closed did one thing and thrown did the other?

?

If that was working, you should try creating the mast but pick “Turnout Controlled Mast” in the Mast Driver entry for the mast.

?

The other thing to try would be checking that Offset Address in the mast you included in your email. That was ‘Marrin LT25 to B5’ mast.

?

But any of these changes, save the panel, then exit and reload so it isn’t confused about things. Some changes require a restart to take effect. This would just insure what you have in the file is what you are using.

?

Also, once you get where the mast works from the mast table, then you have to add it to the panel via the Signal Masts on the turnout. After that, tell it to create the Signal Mast Logic. Then we’ll see what’s working.

?

-Ken Cameron, Member JMRI Dev Team

?

?