Ive just installed 2 Dapol semaphore signals, with a DDC train tech decoder. ?As per the example below.
?
To configure you send a switch command from the CAB,? I did this using the NMRA address 436.? The signal responded to the switch commands. (I also trid the DCC address 440 and that worked as well)
I then tried it from the Turnout control in JMRI, that worked fine.
?
But when I tried it from the panel by closing the turnout of occupying the blocks there is no reaction. ?Below is the signal set up for this mast. ??Have I missed something?
Howard Witt