开云体育

De: "Dave Sand" <ds@...>

贰苍惫辞测é: Dimanche 20 Octobre 2024 19:21:09

Objet: Re: [jmriusers] Something I don't understand - signals not updating

Jean Louis,

There are a couple of minor changes that I would recommend.

In the Layout Editor menu, select Tools -> Check. ?The various sub menus are handy for validation. ?You have an end bumper sitting to the left of the spur track. ?That can be deleted. ?The spur track is connected to an anchor point. ?It is showing yellow which indicates an error. ?It turns out that there is also an end bumper at the same location. ?After moving the anchor point, you can see the end bumper. ?Delete it. ?Then use the right click menu on the anchor point to change it to an end bumper. ?

I prefer to use LogixNG for initialization. ?Since you already have a Route for setting the turnouts, a simple LogixNG works nicely.

Since I am running in simulation mode, I also created a route for the occupancy sensors.

Note: ?DCC++ simulation does not work well so I use LocoNet simulation with the connection prefix set to D. ?I also had to change the turnout feedback to DIRECT.

After the changes, the signals work and running an Dispatcher auto train works properly.

Dave Sand

----- Original message -----

From: Jean-Louis Free <jeanlouisdelestre@...>

To:?[email protected]

Subject: Re: [jmriusers] Something I don't understand - signals not updating

Date: Sunday, October 20, 2024 11:07 AM