|
Ken, To use the JMRI "DCC Signal Decoder" option for signal heads, you have to change the SE74 configuration. On the JMRI side you create the signal heads with addresses based on the SE74 address range. I created four signal heads for LT1 using addresses 100 to 103 without user names. ?Then I moved the user names from the SE8C versions of the signal heads. ?Since the signal masts referred to the signal heads by user name, no changes were required to the signal masts. Since I don't have any hardware, I use the LocoNet Simulator connection. Based on my understanding of the SE74 manual, you need to follow the steps in section 2.1. Dave Sand ----- Original message ----- From: Ken Fordham <j.kenneth.fordman@...> Subject: Re: [jmriusers] SML signal mast problem #sml Date: Sunday, September 08, 2024 4:38 PM Hi Dave I got the switch to show output on and output off but where does the extended accessory decoder set originate from? I didn't understand that and nothing changed on the signals.? ? Best KenF |