tl;dr: What is the configuration of JMRI to connect to a Standalone Loconet via for BT Locobridge and the only contain ComandStations.
Hi, I got a standalone Loconet with products from mollehem.se ¨C?that works fine.
As I bought the Products, I could configure them via JMRI and the Bluetooth interface. It was a bit tricky to get it running. I tried all Comand-Stations ¨C they disconnect the BT-connection to the Interface on start of PanelPro.
But after some trail and error it worked with a connection over a 'LocoNet LocoBuffer'. I saw logs in the log, could configure and control via JMRI.
The Problem is, after that single success I never got it running since then and tried several configurations over the time ¨C No success.
As far as I remember, the Settings have been:
System Manufacturer: Digitrax
System Conection: 'LocoNet LocoBuffer' or 'LocoNet LocoBuffer II'
Serial port: cu.LBridge582
Command station type: Stand-alone LocoNet
I would expect that 'Monitor LocoNet' shows logs when something is happening within Loconet. But wen the connection looks fine, it stays blank (and nothing else works).
MySetup:
JMRI: 5.8
Java: 17.0.11
MacOS: 12.7.5
Is there a recommended configuration to connect via the Bluetooth Interface to a standalone loconet reliable?
