The decoder file (xml/decoders/TCS_WOW_Diesel04.xml) has this for its reset definitions:
<resets>
<mode>PAGEMODE</mode>
<mode>DIRECTMODE</mode>
<mode>OPSBYTEMODE</mode>
<factReset label="Entire decoder (except speed table)" CV="8" default="2"/>
<factReset label="Entire decoder (except address and speed table)" CV="T2CV.5.0" default="2"/>
<factReset label="All sound settings" CV="T2CV.5.0" default="3"/>
<factReset label="Sound Function mappings" CV="T2CV.5.0" default="4"/>
<factReset label="Sound CV's" CV="T2CV.5.0" default="6"/>
<factReset label="Sound type volumes" CV="T2CV.5.0" default="7"/>
<factReset label="User Preset 1" CV="T2CV.5.0" default="8"/>
<factReset label="User Preset 2" CV="T2CV.5.0" default="9"/>
<factReset label="User Preset 3" CV="T2CV.5.0" default="10"/>
<factReset label="Quick Lighting Preset: Standard Ditch Lights" CV="8" default="10"/>
<factReset label="Quick Lighting Preset: Standard Trolley" CV="8" default="11"/>
<factReset label="Quick Lighting Preset: Modified Trilley" CV="8" default="12"/>
</resets>
That means it prefers paged mode, if the command station currently has that available (not all do). If you want to try doing the reset in direct mode you can remove the “PAGEMODE” line from the file.
Alternately, as an experiment, you could try sending those CV operations using the “Single CV programmer” which lets you set the mode directly.
Although it’s worthwhile to try these, I don’t expect that changing the programming mode will change the behavior of the decoder. If it’s accepting the writes (which it sounds like it is, as there’s no error indication), the write mode shouldn’t matter.
Bob
On Apr 30, 2023, at 10:07 AM, Tim Kelley <tim.kelley@...> wrote:
Good morning Bob,
I've been through many of those documents. "Reset / Factory Reset / USER PRESET 1" is what TCS calls their "Nuclear Reset". It is my understanding that
if you have NEVER saved to USER PRESET 1, then doing a Reset / Factory Reset / USER PRESET 1 will load the factory default settings which is what I am
trying to accomplish. My question is if I am programming in Direct Byte Mode on the programming track then why is DecoderPro writing the reset sequences in Paged Mode.
That's what I was seeing in LocoNet Monitor. That doesn't seem correct to me.
—
Bob Jacobsen
rgj1927@...
Bob Jacobsen