On Mon, May 11, 2020 at 05:26 AM, whmvd wrote:
Jamos,
Not directly, no. But what you can do quite efficiently to retain all you
did while working with the wrong definition is put it on the programming
track, read type from decoder, go to the sheet with all the CVs on it and
then read all from decoder. Have a coffee. After a longish while the
reading will finish. There might have been a few read failures on the way,
so sort on the status column so you see those bunched together, and retry
just those until all are read. Then you're good to go.
Wouter
If some fail to read, 'Read Changes on Sheet' will just read just those CVs in red.
--
Peter Ulvestad
JMRI Users Group Moderator - ( )
Tam Valley Group Moderator - ( )
Sprog-DCC Group Moderator - ( )
Edmonton Model Railroad Association -
Peter Ulvestad