Andrew,
On 18 Dec 2019, at 6:33 PM, andrew.woolman <apwool@...> wrote:
FYI, I've tried two different cables on the PowerCab Side of the USB board,
That was a worthwhile test. You should also try two different ports on the PCP (right hand side and rear).
and two different Serial ports on the Mac.
I'm afraid that's a waste of time. The V7.3.7 report with 19200 all ON ruled out problems between Mac and NCE USB.
No diff. Also have tried having the locomotive which I'm trying to read pre-selected with the PowerCab. Again, no difference in results.
I'm afraid that's also a waste of time.
I am eager to hear the next steps. With Thanks!!
We have good progress and need to build on that without taking backward steps.
The good progress is that the V7.3.7 report with 19200 all ON enabled proper communication between the Mac and the NCE USB.
The next problem is now in communication between the NCE USB and the Power Cab. Unfortunately there are more possible causes of issues on this side than with 9,00 baud and all OFF. So I want you to get as far a V7.3.0 report with 9600 and All OFF. There's less to go wrong with that. Please try that again and post a full log for that situation.
Note that you must unplug/replug the Cab Bus Cable any time you change jumpers. The jumpers are only read at power-up (of the 12V side).
Dave in Australia
