Check your LocoNet connections. What you describe is consistent with the connection between JMRI and the command being OK, but something preventing LocoNet connections beyond the command station to the PM42, BDL168, etc boards.
Bob
On Aug 14, 2019, at 6:03 PM, Wayne Swearingen <wayne.swearingen@...> wrote:
Hello All,
I bench tested everything, everything being the command station, PM42, BDL168 and DS64s at home and got them setup properly in JMRI.
I took it all to club and have started setting things up and now am not getting any feedback. I can throw turnouts from JMRI and from the manual push buttons and from throttles but no feedback is indicated when their thrown manual push button/from throttle.
I also am not getting any feedback from block detection. I¡¯ve checked sensors and blocks and all look correct. I can run trains from JMRI throttle so I know it¡¯s ¡°talking¡±. NO block is being detected which makes me think it¡¯s more of a global setting.
I¡¯m sure that¡¯s a pretty minimal start for troubleshooting but where do I start and what information do you need?
Thanks,
Wayne
--
Bob Jacobsen
rgj1927@...
Bob Jacobsen