Hi,
I have built a panel in panelpro using layout editor, so far I am very pleased with the results. ?However I have just added signals to the panel and they do not operate quite as expected. ?
I am using the BR.2003 system and have added a mixture of signals, several dual aspect, one three aspect with feather and several ground signals.
I have set them all up in the signal heads and then signal mast as per the instructions. ?I can change the aspects from either table ok.
I have then added the signal masts to the panel in the locations I want them to be and to some extent I am very happy with the result as I can control the aspect by clicking on the panel.
My confusion comes as when I load the panel all the signals look like a red X. ?I had created a load of routes to set up routes but I also included a reset route which I use at loadup to reset all points closed and all signals red.
The panel updates nicely showing the position of all the points/turnouts but the signals remain as a red X.
How do I get the panel to refresh the signal condition other than me having to go round and click each one several times until showing red.
Hope this makes sense, I cannot find anything in theorem to the help pages.
regards
Doug
