Getting back to the original question you asked, no, there¡¯s not a simple setup to hold an Internal Turnout in one position.
You can create a Logix that looks for the Turnout to change, and commands it back to the state you want. That Logix can also include logic to decide to that only in specific cases, etc. Routes can also do all this, and in some cases are simpler.
It might be helpful to understand a bit why you¡¯d want to do this, as Internal turnouts are, well, internal. There¡¯s no ¡°send¡± involved in "send new command¡±.
Why/how are they getting changed if you don¡¯t want them to be? Might be better to prevent that change there.
Bob
On Aug 8, 2018, at 2:42 AM, Quinametin <quinametin@...> wrote:
Is there an option to setup turnout permanently in one position? I mean when I set it up in JMRI to CLOSED and someone will change it's position by hand on the layout to THROWN JMRI will put it back to CLOSED (and the same the other way when is is THROWN it will be guarded by JMRI to stay THROWN until I will send new command from JMRI)?
I use TWOSENSOR mode to track turnout position. In the AUTOMATION options I only have:
- Off
- Use Global Default
- No feedback
- RAW
and there is no option SENSOR as described here:
I'm using PanelPro 4.13.1 (Mac OS X). All the sensors are INTERNAL sensors connected using Ethernet TCP/IP (for example IS.IOT$[board_addr]:[input#]:[IP])
--
Bob Jacobsen
rgj1927@...
Bob Jacobsen