开云体育

There are a number of sources. It is called an HF-4 connector and eBay has listings as well as Powerwerx. Here is a link https://powerwerx.com/hf4-power-connector-cord-side.

Where can I buy/source the plastic plug with pins to go into 12v receptical on back of the IC-7000?? Is there a particular reference number for that plug?? I want to make my own customized power

Having designed & built many mobiles, I placed ground & power fuses right at the battery, then off to the rig runners. This worked just fine for large

These are okay: https://powerwerx.com/atc-ato-inline-fuse-holder-10-gauge-red Many automotive stores sell 30-amp rated ATO/ATC inline fuse holders, but most use 12 gauge leads, which I have found to

I cut off the OEM holders and use Power Poles, connect it to a Power Pole distribution box that has higher quality fuses. 73! Mark KA6WKE - DM34st Website: https://www.copperstate-it.com Youtube:

Fo you know where I can get some quality fuse holders?

Thank you for all your help! Well it was worth a try !

In my opinion you do not have a salvageable radio. I see corrosion all over the place and that’s probably why it won’t transmit. I wouldn’t invest much time trying to repair this radio, sorry

I have replaced them! All the small ones i have foud this! one off the legs are off. mabye

If you can set idle current correctly, the probability the FET is good is very high. What about the little pre-drivers? There are plenty of other reasons the radio won’t transmit. Thank You

Thanks Paul. I can adjust the idle current ,which i have done. Also I have some extra cables. The board looks perfectly fine.

Not really. The best way is to put the radio into the alignment mode and see if you can adjust the driver idle current. You should be able to set it to 1 amp. It’s adjustment range is from zero to

Can a person test the driver board once it has been desoldered ? And how?

Thank you so much! This rig is driving me nuts now output (very low) until the DRIVO Q504 then nothing!

Yes. Follow the line. It goes direct to the 13.8 volt DC input. Icom radios have DC on the drains or collectors any time the radio is connected to an energized power supply. Thank You Paul W.

Should there be 13.9 volt on J102?

6.82 volts on the gate is pretty high. It’s controlled by the driver bias setting in the service menu. It’s normally around 4 volts and you set it by monitoring the drain current on an external

When testing i get these voltages on my amp A )not transmitting J101 no voltage but there is a voltage of 13.9 volts on J102. B) transmitting J101 there in a volttage of 6.82 volts and a voltage? of

Well folks...I fixed the issue!!!? Eight wraps of the coax thru an FT240-43 ferrite toroid at the radio did the trick!!!? I'm stoked that it worked.?? Apparently the 7000 is very sensitive to RF