开云体育

Yes it goes into tx. believe it or not i can trigger a local repeater even with no output! Strange hey! I will look at the mainboard.

Thanks for sharing your situation.? I looked at your info on QRZ and you have a nice station.? The IC-7000 isn't easy to troubleshoot! Your latest J101 IF measurements looks like the unit isn't

Ment to add i am disabled on the complete right hand side and have very litteled electronic imformation.

The voltages are as follows: J101 Coax from Main IF !.840 cw 3.80mV 3.788 cw 3.20mV 7.100 cw 2.8mV 14.200 cw 3.4mV 28.400 cw 3.0mV 146.00 cw is 3.2 mV I think there is something wrongHere!

Here's the manual for the probe that shipped with that model: https://beyondmeasure.rigoltech.com/acton/attachment/1579/f-06be/1/-/-/-/-/PVP2150%20User%27s%20Guide.pdf On page 4 is the parts list.?

Hi i am using a Rigol ds1104b with the probe hope that helps. i can see each ptest the voltage jumps!

None of the voltages you measured are close to what I normally see.? The first set of levels from the IF should vary with frequency, but yours don't.? They look like just noise levels.? What

The voltages are as follows: J101 Coax from Main IF !.840 cw 136mV 3.788 cw 144mV 7.100 cw 152mV 14.200 cw 160mV 28.400 cw 128mV 146.00 cw is 168 mV Driver Input J101 to J103 !.840 cw 184mV 3.788 cw

Sorry Steve I cannot adjust the output via the service menu. it is very strange!

Andrew,? Are you able to correctly adjust all of the Drive/Final Idling Currents?? For adjusting TX power output, using the correct mic audio level and frequency as specified in procedure is

yes all voltage supplies where checked

Hi, did you test the transistors Or did you just change them hopping that this would work?, did you test for voltage supply on the transistors, Dave wrote:

Guys is there a way i can check the filters. My rig Rx just fine but now out put. 1) the main transistor has been replaced 2) the small transistrs have been replaced (for the transmition) 3) the rigs

The second new 7000 I bought started to have screen problems.? It would show static but never cut off.? I send it back under warranty to Icom twice but it never misbehaved while there.? I got it

https://www.eham.net/classifieds/610710 Not by me, I'm just sharing. Danny

- need to dig into atu icom connector operations to trigger ant from radio and radio from interface A good description of the _START and _KEY signal interaction and status between the Icom Molex

i DON'T BELIEVE THAT THE ic-7000 is compatible with the ATAS (Yaesu). The Yaesu radios have a DC output voltage that changes level to drive up and down or stop. The SWR meter and control circuit in

I have used Icoom AT180 tuner with the 7000, 703 and 706 for many years with great success! 73 de K9UTQ

Thanks to all who replied Larry R., Allison, Wayne, Dom, Rick, Max, John, JD, Rubie, and Larry M. What a group and lots of great info. I think I have come up with a solution of either a tuner such as

I think I have resolved the issue.? I noticed there was oscillation on the 3.3v line on the DDS.? I added a 10uf electrolytic cap to the 3R3V pad above DDS R9 and ground to stabilize the voltage.?