开云体育

I run a 7000 with the AH4 tuner and 102” whip(mobile). It works wonderfully and I’ve been running this for near 5 yrs now. Of course mobile doesn’t quite compare with a good 100 watt base and an

Greetings and Happy new year. I recently needed to change vehicles and I am looking to scale down the whole setup inside and outside the vehicle. I had a tri bander for 2m, 220, and 440 and simply

Hi, I'm having an odd issue with my IC-7000.? It has an odd behavior that it will loose RX and TX when changing the frequency. Power cycling the radio allows it to come back but moving the dial will

My IC-7000 mike cord has developed an intermittent.? I see plenty on the e place for $8.99.? Is there one supplier I should prefer or any I should avoid?? A better place to buy one? Thanks and

Be very careful with the ribbon cables since the 7k has been around for so long the plastic ribbon cables are usually very brittle.

The display has become erratic on my 7000. Powers on and operates properly. But after being on 30 minutes or so the display will blank although the radio continues to operate properly. (Installed

Forgot to add get power at the J101 and then also low at the driver and the finals . But it as low as if not txing

Reception is fine but only transmits about 3 watts on uhf nothing on 2 meters and nothing on hf. the two predrivers havebeen replaced the main driver has been replaced and all the other drivers still

thank you Steve that looks correct. i have found the solder broken in the pic i sent. ok thats not the problem. I have tested the rig and fond no out on the CP951 .and fond the small solder

I recently acquired an IC-7000. Had several Icom units before, never 7k, but I am excited by the “ahead-of-its- time” features. After initial set up the output became erratic - screen fuzzes over

It was Danny.

MP853 is a metal grounding earth spring that was added to the DDS board in 2006.? The picture you attached shows that the spring finger that is about 0.75" long had been broken off.? ?If you look

I took a look in the service manual I got years ago and the only thing I can find is that there's a couple of pages of things that start with MP - in lists called Mechanical Parts, but this manual

Could someone shed some light What is MP853 it is shown only in thesevice manual bud no indication what it does or its use?

From: "Michael Parker" <miketparker@...> Possibilities include paddle "bounce" where the dah side is getting "vibrated" from the dit actuation, or maybe RFI into the keyer causing it to go

Ebay seems to have several listings.

Hi Mike,? Aliexpress list them? on their website? ? ?????? cheers? Mike ZL1BTB (' 7000 owner)

Hello Group, Well down the rabbit hole I go to trying to fix the infamous blown driver board and I started to look for the? PD55015 and it seems everyone is out of stock. Does anyone have an extra

Hi Michael, I admit I'm ignorant. I don't own a Morserino and don't even know what that is, but the artificial intelligence between my ears thinks this sounds like a mode A vs B problem. Just a

There is a separation kit and mount on eBay for over $350. 73’s Don W KD4APP Get Outlook for iOS<https://aka.ms/o0ukef> ________________________________ Sent: Sunday, December 17, 2023 6:41:08