¿ªÔÆÌåÓý

Do you have flrig installed? [Non-text portions of this message have been removed]

one thing to note: if you use the mini DIN port, you can not key with CI-V commands, you have to key via the PTT pin on the mini DIN port. If you use the CI-V keying commands it will put the radio in

More info for those interested, from the service manual. VER.NO. VERSION SYMBOL #02 Europe EUR #03 France FRA #04 Spain ESP #05 U.S.A. USA #08 Export EXP #10 United Kingdom UK Mark. From:

Hi everyone. I just purchased a new IC-7000 last month after many years of using a 706. The serial number on my unit is 2501XXX. Not sure if that means the country code has changed. It is a US version

I can control the transmit/receive function and sat tx rtty BUT it does NOT read the frequency ¨C the rig is controlled by a simple interface via the CVI port and that port controls everything with

Maybe a bad/loose connection? Mine has the "TV" mod (for what it is worth ;) ) and sometimes when I exert moderate pressure on the bottom of the control panel, the display goes all goofy (i.e.,

The 05 is the North American country code, so your unit is # 13403 off the line for NA. There are no coded messages in any of the numbers on the box. There haven't been any significant changes in

The most common cause of low TX power output is the poor quality fuse holders Icom uses on the DC power cables. They develop an oxidation layer between the contact and fuse blade, causing excessive

The CI-V provides only rig control, not audio in/out. You still need the audio interface. Most digital programs use a serial port to control the PTT. Since most newer computers don't have serial

I posted the firmware versions for my two radios in: http://groups.yahoo.com/group/ic7000/message/27790 If recent radios have something different, let the group know. Steve, W3AHL ..snip..

Too expansive in France... 130 €... Prefer : www.radioarena.co.uk and audio usb key Best regards, Ludovic - F5PBG http://f5pbg.free.fr

Hi All Thank you all for the help you passed on during my question "Setup". Iv got all the replies and condensed them down into a printed sheet to help me. Iv also gone(going through) the main manual

I RECOMMEND THE SIGNALINK.?I USE IT FOR MIX W, DIGIPAN AND FIDIGI. ORDER ONE WITH THE 6 PIN MINI DIN AND WITH THE USB FOR YOUR COMPUTER. KC5IAJ, BUD ? ? To: ic7000@... Sent: Friday,

Hi all. The RF output is dropping. When the radio is turned on full output. If it is on for a length of time it starts too drop off. example 20 meter setting 100W at power up or shortly after output

I purchased mine on January 20th, 2012 from HRO in Portland, OR and it has a serial number of 0516722 I see a lot of these posts but no info on whether there are any updates to the radio. Terry W5NRA

The Signalink USB generates PTT via internal VOX. You would need a CI-V interface only if you want CAT control of mode/frequency, etc. I will say it's very handy to have that control, especially if

I find the mini-Din plug to be the preferred connection for a signalink to my IC-7000: it disables the microphone on the IC-700 during transmit. I have the PTT line from the Signalink controlling the

The answer is...... yes! Look on page 12 of the manual. Also, the Signal Link cable is all set for this, just make sure the jumpers are right. The good thing about the Signal Link and using the 6 pin

Thank You Gentlemen, 1 more question. Will I be able to key the rig using the mini-DIN, or will I need to also use the CI-V port for PTT? Bill