开云体育

Geoff Ditto: educational not annoying Kurt KD6LZV

Hi all I checked ic551 pins 10 - 14 and only pin 10 has the 24mhz clock, 11-14 are 0v no activity at all- even from a power off to on state. I ordered a replacement IC from China - will take a week or

Geoff, These posts on troubleshooting are interesting, not annoying. They're good reading. Bob W4JFA [email protected]> wrote:

I recently bought an IC-7000.? During my very first QSO (on QRP 70cm CW) my QSO partner (Chris GU3TUX) noticed frequency jumps at the start of each of my transmissions.? He kindly informed me, and I

Hi Geoff Nothing out of IC551 pins 25 and 26 which feed IC601 , ic601 is underneath so very hard to get to but checked on ic551 pins 25 and 26 and nothing at all with a good clean signal on pin 4. i

James, The datasheet for IC551 is on the internet and maybe worth a look. You say you have the analogue signal at IC551 is it pin 4. Can you see anything at R611, R615, or the filter device IC601

Thanks PaulYes that's expensive.Looking for a parts radio nowRegards?James? Yahoo Mail: Search, Organize, Conquer

Logic units have been a relatively high failure item. Icom never even attempted to repair them except for the CI-V components. The latest price list I have from Icom does list the part as being

Hi PaulYes just wanted to reach out to see if you have any experience with the logic board on the 7000My 7000 could have the fault?RegardsJames? Yahoo Mail: Search, Organize, Conquer

Hi Tommy Not sure, the audio in and out of this IC also go through the DSP. The fact that no audio passes through this chip Rx or tx either means a complete failure of ic551 or the DSP has some issue

James Did you conclude IC551 is bad? Tommy KF4RWG [email protected]> wrote:

Is this for me? Thank You Paul W. Hansen, W6XA Amateur Radio Service 2134 Carthage Road Tucker, GA 30084 (864) 222-3539 www.amateurradioservice.com Sent: Sunday, November 3, 2024

looks like the logic board is faulty. looking for a replacement now TBC

Hi Paul I have a 7000 with no audio on rx and will not tx. I think its the logic board are these boards available? james

IC551

James, Keep up the good work. Keep us posted. We all appreciate your information. Bob W4JFA [email protected]> wrote:

Checked? CW tx using keyer input and radio not going into TX mode .more work to do ....

Hi Geoff looks like dds 2nd osc is ok at 124.032 and 1st local osc varies with tuning knob so looks like front end might be ok and the dsp board may be the culprit. i need to confirm signal present at

Hi James, If you confirm the audio amp is ok then you need to look further back. At least now you know that if you fix an upstream fault you should hear something. The fact that you acquired this

tried with an earphone in the headset socket top rhs next to band switch ??