I'd suggest two crossing lines with the lasers attached to the
drill table.? You can often buy "line" lasers that put out a line
rather than a point.? If you have difficulty finding some, I'd
suggest taking apart some very cheap laser line levels for parts.?
It's just a laser pointer with an odd lens.? If you can, 3D
printing is likely your friend.? You want a holder that's sturdy,
but still attaches to the table to give you a maximum size.
You could also mount a TV camera under the table, with a 45
degree mirror, put a set of crosshairs on the monitor, and that
works as well.
Harvey
On 5/6/2019 8:42 AM, Kevin Byrne via
Groups.Io wrote:
toggle quoted message
Show quoted text
I just bought a quality drill motor and drill press from Jameco
and need help with a laser siteing idea to put a laser dot under
board in center of hole to be drilled.
Has anyone done this that has a parts list I can adapt to my
press? How about a cross hatch on top of board? Which would be
best? I am open to ideas and looking for assistance.
