Yes, CNC rules. I have a few 3D Printers. I though about CNC'ing (is that a word?) my mill but then I figured I would want handles on it too for manual work as everything in CNC would likely not be a great idea. Most of the CNC mills seem to lack the handles or maybe I didn't look hard enough but I know turning a stepper motor can mess up some controller boards as they generate voltage when you do that and back feed the board.
toggle quoted message
Show quoted text
On 3/4/2019 8:25 PM, Harvey White wrote:
On Mon, 4 Mar 2019 17:39:37 -0600, you wrote:
Harvey,
? Yes, all good info. My Proxxon just arrived so I will been opening
the little box and see what I bought. :)? I figure 8500 rpms will be
fine and being it's a hobby I will be ok. I have a large milling machine
and learned a lot from using it. Too bad it isn't CNC. :)
One of these days, I'll complete the CNC conversion on my X1...
Harvey
