开云体育

I gave a complete answer in saying that the 8444-Kit is the correct one. You can look it up here (for example): https://www.fishorgans.com/leslie_kits/8444_kit_for_Hammond.pdf How it is electrically

You mix the signals together using resistors. I think Chris has a schematic on hammond wilki.

Yes, this is possible. The 8444 kit is the one for this purpose. Actually, the Leslie 251 would be the right one for this purpose, since rotating (vortexing?) the reverb may sound ?cheesy“. Not

yes Sent: Monday, April 27, 2020 11:59 AM To: [email protected] Subject: [hammondzone] Reverb on A100 to 147 leslie I heard years ago you could connect the reverb from an A100 to a 147 Leslie but

I heard years ago you could connect the reverb from an A100 to a 147 Leslie but through my limited knowledge I can't understand how. Is this possible or not ? Jim Mc

I have found a schematic of the organ mate, https://el34world.com/Forum/index.php?action=dlattach;topic=20468.0;attach=59026;image. Looking at this, I would expect a lowish input impedance, and a high

IIRC the reverb tank on the Organ Mate reverb is the same as e.g. used in the A-100, that is, low impedance input (since driven from the speakers - with that bulb shunt in series). The Organ Mate has

Also, if you can measure the resistance of the transducer windings, this will give you some idea of the impedance. Generally the impedance will be somewhat higher than the resistance measured with a

You can start here:https://www.amplifiedparts.com/tech-articles/accutronics-products-and-specifications The people at amplified parts can most likely sell you the right one.

Does anyone happen to know the specs on the tanks used on the Organmate Reverb units?? I've got one here with a busted connector at one of the transducers.? I don't see any model number on the tank

Having just watched your Youtube video, I suspect that the volume of the hum increased as you opened the swell pedal. If so the hum is getting into the organ circuits somewhere. A likely cause, as

Will do and report back

Joel , Always remember that the Leslie must be to the right of the organ or it will hum. Your picture wasn't showing enough info. Try moving it as far to the right of the organ as possible.? (

Thanks Scott

Correct in the USA.

Thank you Chris for your very swift reply. Yes my MEE switch has two sides and nine wires, info noted re the resistors. One final possibly dumb question if you don't mind. My A100 has been messed with

The installation instructions here, http://www.fishorgans.com/leslie_kits/008253_kit_for_Hammond.pdf have a diagram of the internal wiring of the 011874 connector box. The main things you will need

Hi I am trying to connect my Hammond A100 to my Leslie 251 (with the reverb going to the second stationary Chanel) Parts I have - Leslie half moon Main-Ensemble-Echo switch and Chorale-Tremolo switch,

Hi - new to me Leslie 147A - connected via 6 conductor cable to my B3 console. Wiring to 6 pin socket is as follows: Pin 1 - brown Pin 2 - Leslie half moon Pin 3 - gray and other leg of Leslie half

Hi - I picked up a Leslie 147A for my B3 and finally got around to adding a 6 pin socket to my interface box. I’m getting some hum from the Leslie 147A which I didn’t get with my old 770. I dont