Re: X-66 Trouble shooting Help
|
Hey Jim -
Thanks for your input.? Did what you said with the exception of the BusBar.? I couldn't find any reference to them on the X-66 so don't think it has them.? I could be wrong,.? I know my other Hammonds do.? No change inn the organ performance or lack thereof.
Additional note on the noise:? It sounds like a motor spinning up and them stabilizing.? Any chance the drive motor on the Tonewheel generator could be causing a problem?? This organ doesn't have a grounded plug.? Should I run a ground to the chassis?
Thanks again Jim.
Bob
-----Original Message-----
From: Diayne McComis <diayne@...>
To: hammondzone < [email protected]>
Sent: Fri, Jan 31, 2020 9:05 am
Subject: Re: [hammondzone] X-66 Trouble shooting Help
I had one years ago but not those problems. Try this with the organ on and med volume.
Push all resets on and off to see if it changes, do the tabs the same way this may take several times. On the left side, try holding down the cancel key while rapidly pushing each preset about 20 times as fast as you can, you are looking for some change in tones, next ? try shifting the busbars, also it sounds like it could be in the filter section. The tone cabinets only produce sounds from the organ not on their own unless it was a hum.
Let Me Know if it changes, ? Jim Mc
|
